NFK3-SC FLUKE NETWORKS, NFK3-SC Datasheet - Page 168

• Manufacturer Part Number: NFK3-SC
• Description: LAN Tester
• Manufacturer: FLUKE NETWORKS

Specifications of NFK3-SC

• Lead Free Status / RoHS Status: na

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
Running the Test in Smart Remote Mode
1
2
3
4
7-16
If you disconnected the reference test cords from
the tester’s or remote’s output, you must set the
reference again to ensure valid measurements.
Verify that the settings described in Table 7-1 are
appropriate. Let the testers warm up for 5 minutes.
Set the main tester to loss/length mode: On the HOME
screen, press
Clean the connectors on the cabling to be tested; then
connect the tester to the cabling as shown in Figure
7-7.
For auto-incrementing fiber IDs, connect the fiber with
the lower ID to the main tester’s INPUT port. For auto-
incrementing fiber IDs with bi-directional testing,
connect the fiber with the lower ID to the main tester’s
OUTPUT port.
Press
T
to start the loss/length test.
A
Change Test; then select Loss/Length.
W
Caution
5
6
If Open or Unknown appears as the status, try the
following:
•
•
•
•
•
To save the results, press
ID for the INPUT fiber; then press
create a fiber ID for the OUTPUT fiber; then press
s
Verify that all connections are good.
For an OptiFiber smart remote verify that the
remote tester is set to Remote on its Loss/Length
tab in Setup.
Verify that the remote tester is still active. For an
OptiFiber smart remote you may need to press
A
Try different connections to the cabling until the
test continues. See “Using FindFiber in Smart
Remote Mode” on page 7-39 for details on
FindFiber messages.
Use a visible light source to verify fiber continuity.
again.
Start to reactive the tester.
s
, select or create a fiber
s
. Select or