NFK3-SC FLUKE NETWORKS, NFK3-SC Datasheet - Page 184

• Manufacturer Part Number: NFK3-SC
• Description: LAN Tester
• Manufacturer: FLUKE NETWORKS

Specifications of NFK3-SC

• Lead Free Status / RoHS Status: na

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
1
2
3
4
5
6
7
8
7-32
If you disconnected the reference test cord from
the source's output, you must set the reference
again to ensure valid measurements.
Verify that the settings described in Table 7-1 are
appropriate. Let the tester and source warm up for 5
minutes.
Select Loss/Length mode: On the HOME screen, press
A
Clean the connectors on the cabling to be tested.
Connect the tester to the cabling as shown in Figure
7-13.
Set the source to the correct wavelength and to
continuous wave output.
Press
Select a wavelength for the test. Auto is used with
SimpliFiber sources, as described in the next section.
To test at a second wavelength, repeat steps 5 through
7.
Change Test; then select Loss/Length.
T
.
W
Caution
9
Using Auto Wavelength Detection with
SimpliFiber Sources (OFTM-5731 and OFTM-5732
Modules)
A Fluke Networks SimpliFiber source can transmit
wavelength information that can be read by OFTM-5731
and OFTM-5732 modules. This feature helps eliminate
wavelength selection errors when testing in Far End Source
mode.
To use auto wavelength detection, do the following:
1
2
3
To save the results, press
ID; then press
If you tested at two wavelengths, both are stored in
the same record.
Verify that the SimpliFiber source is set to Auto mode.
The Auto LED should be lit. Press
Press
For SimpliFiber Pro sources, only one wavelength LED
must be on. The LEDs must not be blinking alternately.
Run the Far End Source test, selecting Auto on the
tester's SET SOURCE WAVELENGTH screen.
Z
to select a wavelength (850 nm or 1300 nm).
s
again.
s
, select or create a fiber
A
if it is not.