NFK3-SC FLUKE NETWORKS, NFK3-SC Datasheet - Page 59

• Manufacturer Part Number: NFK3-SC
• Description: LAN Tester
• Manufacturer: FLUKE NETWORKS

Specifications of NFK3-SC

• Lead Free Status / RoHS Status: na

Step 2: Setting Up a Job Folder
You can organize test results on the memory card by setting
up a folder for each job, as follows:
2-1
2-2
2-3
2-4
2-5
Step 3: Entering the Operator Name
For this tutorial you will enter your name as the operator.
3-1
3-2
Insert a formatted memory card into the tester.
Press
tab.
Press
and
NAME box. Figure 2-1 describes the text editing screen.
Press
Press
Press
Use the softkeys,
name into the OPERATOR box. Press
are finished.
t
S
A
s
t
S
to enter a folder name into the NEW FOLDER
New Folder. Use the softkeys,
to select the new folder as the current folder.
; then select CURRENT FOLDER on the Job
; then select OPERATOR on the Job tab.
when you are finished.
K NML
, and
t
s
to enter your
K NML
when you
,
Step 4: Identifying the Cabling Ends
For the OTDR and Loss/Length testing tutorials in this
chapter, you will save test results from both ends of the
cabling. To identify the test directions in the saved results,
enter END information on the Job tab as follows:
4-1 On the Job tab select END 1. Use the softkeys,
4-2 On the Job tab select END 2. Use the softkeys,
4-3 On the Job tab, verify that THIS END is set to END 1.
Step 5: Setting the Save Warning
If you do not save a test, it is deleted from temporary
memory when you run another test. To enable or disable a
warning that reminds you to save the test, do the
following:
5-1 On the System tab, select SAVE WARNING.
5-2 Use
NML
box. Press
ML
box. Press
Change it to END 1 if necessary.
press
LM
t
, and
, and
Tutorial: Preparing to Save Tests
.
s
s
to highlight Enabled or Disabled; then
t
Getting Started Testing Fiber
t
when you are finished.
when you are finished.
to enter WORK AREA into the END 2
to enter CLOSET into the END 1
K
K N
2-11
2