AT85C5122D-SISUM Atmel, AT85C5122D-SISUM Datasheet - Page 161

• Manufacturer Part Number: AT85C5122D-SISUM
• Description: RFID Modules & Development Tools 3-5.5V Smart Card Reader
• Manufacturer: Atmel

Specifications of AT85C5122D-SISUM

• Product: RFID Readers

INT1 Interrupt Vector
INT1 Input
RXD Input
CPRES Input
4202E–SCR–06/06
The INT1 interrupt is multiplexed with the following three inputs:
•
•
•
The setting configurations for each input is detailed below.
This interrupt input is active under the following conditions :
•
•
•
The Bit IE1 (TCON Register) is set by hardware when external interrupt detected. It is
cleared when interrupt is processed.
A second vector interrupt input is the reception of a character. UART Rx input can gen-
erate an interrupt if enabled with Bit RXEN (ISEL.0). The global enable bits EX1 and EA
must also be set.
Then, the Bit RXIT (ISEL Register) is set by hardware when a low level is detected on
P3.0/RXD input.
The third input is the detection of a level change on CPRES input (P1.2). This input can
generate an interrupt if enabled with PRESEN (ISEL.1) , EX1 (IE0.2) and EA (IE0.7)
Bits.
This detection is done according to the level selected with Bit CPLEV (ISEL.7).
Then the Bit PRESIT (ISEL.5) is set by hardware when the triggering conditions are
met. This Bit must be cleared by software.
INT1 : Standard 8051 interrupt input
RXD : Received data on UART
CPRES: Insertion or remove of the main card
It must be enabled by OEEN Bit (ISEL Register)
It can be active on a level or falling edge following IT1 Bit (TCON Register) status
If level triggering selection is set, the active level 0 or 1 can be selected with OELEV
Bit (ISEL Register)
AT8xC5122/23
161