FW82801DB S L66K Intel, FW82801DB S L66K Datasheet - Page 161
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
FW82801DB S L66K
Manufacturer Part Number
FW82801DB S L66K
Description
Manufacturer
Intel
Datasheet
1.FW82801DB_S_L66K.pdf
(587 pages)
Specifications of FW82801DB S L66K
Lead Free Status / RoHS Status
Supplier Unconfirmed
- Current page: 161 of 587
- Download datasheet (7Mb)
5.14.2
5.14.3
5.15
Intel
®
82801DB ICH4 Datasheet
Power Wells
Some GPIOs exist in the resume power plane. Care must be taken to make sure GPIO signals are
not driven high into powered-down planes.
Some ICH4 GPIOs may be connected to pins on devices that exist in the core well. If these GPIOs
are outputs, there is a danger that a loss of core power (PWROK low) or a Power Button Override
event will result in the ICH4 driving a pin to a logic 1 to another device that is powered down.
GPIO[1:15] have “sticky” bits on the input. Refer to the GPE0_STS register. As long as the signal
goes active for at least 2 clocks, the ICH4 will keep the sticky status bit active. The active level can
be selected in the GP_LVL register.
If the system is in an S0 or an S1 state, the GPI inputs are sampled at 33 MHz, so the signal only
needs to be active for about 60 ns to be latched. In the S3–S5 states, the GPI inputs are sampled at
32.768 kHz, and thus must be active for at least 61 microseconds to be latched.
If the input signal is still active when the latch is cleared, it will again be set. Another edge trigger
is not required. This makes these signals “level” triggered inputs.
SMI# and SCI Routing
The routing bits for GPIO[0:15] allow an input to be routed to SMI# or SCI, or neither. Note that a
bit can be routed to either an SMI# or an SCI, but not both.
IDE Controller (D31:F1)
The ICH4 IDE controller features two sets of interface signals (Primary and Secondary) that can be
independently enabled, tri-stated or driven low. The ICH4 IDE controller supports both legacy
mode and native mode IDE interface. In native mode, the IDE controller is a fully PCI compliant
software interface and does not use any legacy I/O or interrupt resources. The IDE interfaces of the
ICH4 can support several types of data transfers:
•
•
•
•
•
Programmed I/O (PIO): Processor is in control of the data transfer.
8237 style DMA: DMA protocol that resembles the DMA on the ISA bus, although it does not
use the 8237 in the ICH4. This protocol off loads the processor from moving data. This allows
higher transfer rate of up to 16 MB/s.
Ultra ATA/33: DMA protocol that redefines signals on the IDE cable to allow both host and
target throttling of data and transfer rates of up to 33 MB/s.
Ultra ATA/66: DMA protocol that redefines signals on the IDE cable to allow both host and
target throttling of data and transfer rates of up to 66 MB/s.
Ultra ATA/100: DMA protocol that redefines signals on the IDE cable to allow both host and
target throttling of data and transfer rates of up to 100 MB/s.
Functional Description
161
Related parts for FW82801DB S L66K
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![FW82801DB S L6DM](/images/manufacturer_photos/0/3/336/intel_tmb.jpg)
Part Number:
Description:
Manufacturer:
Intel
Datasheet:
![RJ80535VC600512](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
![82550GY](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![G28F640J5-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-100](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
![DA28F640J5A-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
![NHE6300ESB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
![NH82801DB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet:
![FW82801FB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801FB I/O Controller Hub (ICH6)
Manufacturer:
Intel Corporation
Datasheet: