FW82801DB S L66K Intel, FW82801DB S L66K Datasheet - Page 97
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
FW82801DB S L66K
Manufacturer Part Number
FW82801DB S L66K
Description
Manufacturer
Intel
Datasheet
1.FW82801DB_S_L66K.pdf
(587 pages)
Specifications of FW82801DB S L66K
Lead Free Status / RoHS Status
Supplier Unconfirmed
- Current page: 97 of 587
- Download datasheet (7Mb)
5.5.2
Intel
®
82801DB ICH4 Datasheet
All PCI DMA expansion agents must use the channel passing protocol described above. They must
also work as follows:
The three cases above require the following functionality in the PCI DMA expansion device:
PCI DMA Expansion Cycles
ICH4’s support of the PC/PCI DMA Protocol currently consists of four types of cycles: Memory to
I/O, I/O to Memory, Verify, and ISA Master cycles. ISA Masters are supported through the use of a
DMA channel that has been programmed for cascade mode.
The DMA controller does a two cycle transfer (a load followed by a store) as opposed to the ISA
"fly-by" cycle for PC/PCI DMA agents. The memory portion of the cycle generates a PCI memory
read or memory write bus cycle, its address representing the selected memory.
•
•
•
•
•
•
If a PCI DMA expansion agent has more than one request active, it must resend the request
serial protocol after one of the requests has been granted the bus and it has completed its
transfer. The expansion device should drive its REQ# inactive for two clocks and then transmit
the serial channel passing protocol again, even if there are no new requests from the PCI
expansion agent to ICH4. For example: If a PCI expansion agent had active requests for DMA
channel 1 and channel 5, it would pass this information to ICH4 through the expansion
channel passing protocol. If after receiving GNT# (assume for CH5) and having the device
finish its transfer (device stops driving request to PCI expansion agent) it would then need to
re-transmit the expansion channel passing protocol to inform ICH4 that DMA channel 1 was
still requesting the bus, even if that was the only request the expansion device had pending.
If a PCI DMA expansion agent has a request go inactive before ICH4 asserts GNT#, it must
resend the expansion channel passing protocol to update ICH4 with this new request
information. For example: If a PCI expansion agent has DMA channel 1 and 2 requests
pending it will send them serially to ICH4 using the expansion channel passing protocol. If,
however, DMA channel 1 goes inactive into the expansion agent before the expansion agent
receives a GNT# from ICH4, the expansion agent MUST pull its REQ# line high for ONE
clock and resend the expansion channel passing information with only DMA channel 2 active.
Note that ICH4 does not do anything special to catch this case because a DREQ going inactive
before a DACK# is received is not allowed in the ISA DMA protocol and, therefore, does not
need to work properly in this protocol either. This requirement is needed to be able to support
Plug-n-Play ISA devices that toggle DREQ# lines to determine if those lines are free in the
system.
If a PCI expansion agent has sent its serial request information and receives a new DMA
request before receiving GNT#, the agent must resend the serial request with the new request
active. For example: If a PCI expansion agent has already passed requests for DMA channel 1
and 2 and sees DREQ 3 active before a GNT is received, the device must pull its REQ# line
high for one clock and resend the expansion channel passing information with all three
channels active.
Drive REQ# inactive for one clock to signal new request information.
Drive REQ# inactive for two clocks to signal that a request that had been granted the bus has
gone inactive.
The REQ# and GNT# state machines must run independently and concurrently (i.e., a GNT#
could be received while in the middle of sending a serial REQ# or a GNT# could be active
while REQ# is inactive).
Functional Description
97
Related parts for FW82801DB S L66K
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![FW82801DB S L6DM](/images/manufacturer_photos/0/3/336/intel_tmb.jpg)
Part Number:
Description:
Manufacturer:
Intel
Datasheet:
![RJ80535VC600512](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
![82550GY](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
![G28F640J5-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5-100](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
![DA28F640J5A-150](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
![DA28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
![E28F320J5A-120](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
![NHE6300ESB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
![NH82801DB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet:
![FW82801FB](/images/manufacturer_photos/0/3/337/intel_corporation_tmb.jpg)
Part Number:
Description:
Intel 82801FB I/O Controller Hub (ICH6)
Manufacturer:
Intel Corporation
Datasheet: