LMK04031BISQ National Semiconductor, LMK04031BISQ Datasheet - Page 50

• Manufacturer Part Number: LMK04031BISQ
• Manufacturer: National Semiconductor

Specifications of LMK04031BISQ

• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Pin Count: 48
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Not Compliant

www.national.com
Figure 22
VCXO “A” and VCXO “B”. Both VCXOs have a center fre-
quency of 100 MHz. The figure of merit, RMS jitter, is mea-
This plot shows that VCXO “B” exhibits superior phase noise
when compared to VCXO “A”. Both VCXOs offer excellent
jitter performance from 100 Hz to 200 kHz. VCXO “A” exhibits
RMS jitter of 151 femtoseconds (fs), while VCXO “B” has RMS
jitter of 90 fs.
Figures 23, 24, 25 present a side-by-side comparison of clock
output phase noise at 250 MHz, organized by output format
and associated VCXO. The total RMS jitter listed on the plots
is integrated from 100 Hz to 20 MHz. Examining these plots,
the clock output phase noise associated with VCXO “B” is
superior in all cases. The average improvement in RMS jitter
due to VCXO “B” is approximately 47 fs. The plots show the
primary difference in clock output phase noise is in the band
from 100 Hz to approximately 4 kHz. Across this range, the
VCXO phase noise dominates that of the PLL, given the loop
bandwidth of this design, which is 152 kHz. Above 4 kHz, the
PLL noise dominates (inside the loop bandwidth), so it is ba-
compares the phase noise of two different VCXOs:
FIGURE 22. VCXO Phase Noise Comparison, 100 MHz
50
sured over the bandwidth 100 Hz to 200 kHz. This is the most
relevant integration bandwidth for the VCXO because it will
have the most impact inside the loop bandwidth of PLL2.
sically the same for either VCXO. Comparing the jitter of two
VCXOs in the 100 Hz to 4 kHz band, it can be shown that
VCXO “A” exhibits jitter of 142 fs, and VCXO “B” exhibits jitter
of 90 fs. The difference, 52 fs, accounts for the majority of the
average difference in RMS jitter at the clock outputs when
comparing VCXOs.
The PLL configurations listed below were the same for both
VCXOs/LMK040xx pair:
•
•
•
•
PLL1 loop filter components: C1 = 100 nF, C2 = 680 nF,
R2 = 39 kΩ
PLL1 f
PLL2 loop filter components: C1 = 0, C2 = 12 nF, R2 = 1.8
kΩ
PLL2 f
kHz
PD
PD
= 1 MHz, CP gain = 100 µA, loop BW = 20 Hz
= 25 MHz, CP gain = 3200 µA, loop BW = 152
30027147