A000003 Arduino, A000003 Datasheet - Page 33

• Manufacturer Part Number: A000003
• Description: MCU, MPU & DSP Development Tools MINI
• Manufacturer: Arduino
• Series: -r
• Type: MCUr

Specifications of A000003

• Processor To Be Evaluated: Atmega328
• Processor Series: ATmega
• Data Bus Width: 8 bit
• Interface Type: USB, RS-232
• Operating Supply Voltage: 7 V to 9 V
• Contents: Board
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATmega168

8.7
2545S–AVR–07/10
128 kHz Internal Oscillator
Table 8-8.
Notes:
When this Oscillator is selected, start-up times are determined by the SUT Fuses as shown in
Table 8-9 on page
Table 8-9.
Note:
The 128 kHz internal Oscillator is a low power Oscillator providing a clock of 128 kHz. The fre-
quency is nominal at 3V and 25°C. This clock may be select as the system clock by
programming the CKSEL Fuses to “11” as shown in
Table 8-10.
Note:
When this clock source is selected, start-up times are determined by the SUT Fuses as shown in
Table
Table 8-11.
Note:
Power Conditions
BOD enabled
Fast rising power
Slowly rising power
BOD enabled
Fast rising power
Slowly rising power
Power Conditions
8-11.
1. The device is shipped with this option selected.
2. If 8 MHz frequency exceeds the specification of the device (depends on V
1. If the RSTDISBL fuse is programmed, this start-up time will be increased to
2.
1. Note that the 128 kHz oscillator is a very low power clock source, and is not designed for a
1. If the RSTDISBL fuse is programmed, this start-up time will be increased to
The device is shipped with this option selected.
Fuse can be programmed in order to divide the internal frequency by 8.
14CK + 4.1 ms to ensure programming mode can be entered.
high accuracy.
14CK + 4.1 ms to ensure programming mode can be entered.
Frequency Range (MHz)
Internal Calibrated RC Oscillator Operating Modes
Start-up times for the internal calibrated RC Oscillator clock selection
128 kHz Internal Oscillator Operating Modes
Start-up Times for the 128 kHz Internal Oscillator
33.
Nominal Frequency
7.3 - 8.1
128 kHz
Start-up Time from Power-
Start-up Time from Power-
down and Power-save
down and Power-save
Reserved
Reserved
6 CK
6 CK
6 CK
6 CK
6 CK
6 CK
Table
8-10.
Additional Delay from
Additional Delay from
ATmega48/88/168
Reset (V
14CK + 65 ms
14CK + 4.1 ms
(1)(2)
14CK + 64 ms
14CK + 4 ms
CKSEL3..0
14CK
14CK
Reset
0010
CC
CKSEL3..0
(1)
(1)
= 5.0V)
0011
(2)
CC
), the CKDIV8
SUT1..0
SUT1..0
00
01
10
11
00
01
10
11
33