DSP-DEVKIT-2S60 Altera, DSP-DEVKIT-2S60 Datasheet - Page 55

• Manufacturer Part Number: DSP-DEVKIT-2S60
• Manufacturer: Altera

Specifications of DSP-DEVKIT-2S60

• Lead Free Status / Rohs Status: Not Compliant

Using the Board
Altera Corporation
This chapter describes how to get started with the board, including using
the board, non-volatile confirguration, and applying and removing the
heat sink from the Stratix
DSP Development Kit, Stratix II Edition Getting Started User Guide.
When power is applied to the board and SW9 is in the "ON" position, the
Power-on LED (LED7) illuminates. At that time, the MAX device (U10)
programs the Stratix II device (U18) from one of 4 flash memory spaces
reserved for configuration information. If configuration is successful, the
CONF_DONE LED (LED5) illuminates.
1
To configure the board with a new design, the designer should perform
the following steps, explained in detail in this section.
4.
5.
Apply Power
Apply power to the board by connecting the 16-V DC power supply
adapter, provided in the DSP Development Kit, Stratix II edition, to the
on-board power adapter connector (J22), and switching SW9 to the ON
position. All of the board components draw power either directly from
this 16-V supply or from the 3.3-V, 1.2-V, and 5-V regulators that are
powered by the 16-V supply.
1
When power is applied to the board, the Power On LED (LED7)
illuminates.
Apply power to the board.
Re-configure the Stratix II device.
If the Stratix II device is programmed with a design in one of the
user configuration memory spaces or using the JTAG connector
(J21), both the CONF_DONE LED (LED5) and the USER LED
(LED1) illuminate. For more information, refer to
“Configuration-Status LEDs” on page
The 3.3-V supply provides V
LVTTL board components. The 1.2-V supply provides V
the Stratix II device.
Reference Manual
Chapter 3. Getting Started
®
II device. For more information, refer to the
CCIO
to the Stratix II device and all
2–8.
August 2006
CCINT
3–1
to