DSP-DEVKIT-2S60 Altera, DSP-DEVKIT-2S60 Datasheet - Page 60

• Manufacturer Part Number: DSP-DEVKIT-2S60
• Manufacturer: Altera

Specifications of DSP-DEVKIT-2S60

• Lead Free Status / Rohs Status: Not Compliant

Install or Remove the Active Heat Sink
3–6
Stratix II Development Board
To mount the active heat sink to the board, perform the following steps:
1.
2.
3.
4.
w
Remove the Active Heat Sink
To remove the heat sink and fan from the board, perform the following
steps:
1.
2.
3.
w
Peel off the film covering the thermal tape on the bottom of the
heatsink.
Center the heat sink on top of the Stratix II FPGA. The active heat
sink can be mounted in two directions; mount it so the wires are as
close as possible to the J36 connector. When connected, these wires
supply the 5 V DC power to the fan.
Push the heat sink down onto the Stratix II device and hold it there
for 30 seconds.
Attach the heat sink fan power connector to the J36 connector, for
5 V DC power. The red wire should connect to pin 1 of J36, which is
noted with a dot on the silkscreen.
Disconnect the heat sink fan power connector from the J36
connector.
Insert a thin device such as a knife or small screwdriver between the
heat sink and the Stratix II device.
Pry the thermal tape loose and remove the heat sink from the
device.
Do not connect this connector backwards or you will damage
the fan.
Do not pull the heat sink off of the Stratix II device because this
action may cause the device to break off of the board. Always
pry the heat sink off.
Reference Manual
Altera Corporation
August 2006