AT32UC3L064 Atmel Corporation, AT32UC3L064 Datasheet - Page 104

• Manufacturer Part Number: AT32UC3L064
• Manufacturer: Atmel Corporation

Specifications of AT32UC3L064

• Flash (kbytes): 64 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

10.4.23
10.5
32099G–06/2011
I/O Pins
Fix/Workaround
Solution 1: Disable OSC0 by writing a zero to the Oscillator Enable bit in the System Control
Interface (SCIF) Oscillator Control Register (SCIF.OSC0CTRL.OSCEN) before going to a
sleep mode where OSC0 is disabled.
Solution 2: Pull down or up XIN0 and XOUT0 with 1MOhm resistor.
PB10 is not 3.3V tolerant.
PB10 should be grounded on the PCB and left unused.
Fix/Workaround
None.
Analog multiplexing consumes extra power
Current consumption on VDDIO increases when the voltage on analog inputs is close to
VDDIO/2.
Fix/Workaround
None.
PA02, PB01, PB04, PB05, and RESET_N have half of the pull-up strength
Pins PA02, PB01, PB04, PB05, and RESET_N have half of the specified pull-up strength.
Fix/Workaround
None.
JTAG is enabled at power up
The JTAG function on pins PA00, PA01, PA02, and PA03, are enabled after startup. Normal
I/O module functionality is not possible on these pins.
Fix/Workaround
Add a 10kOhm pullup on the reset line.
MCKO and MDO[3] are swapped in the AUX1 mapping
When using the OCD AUX1 mapping of trace signals MDO[3] is located on pin PB05 and
MCKO is located on PB01.
Fix/Workaround
Swap pins PB01 and PB05 if using OCD AUX1.
AT32UC3L016/32/64
104