ATxmega16A4 Atmel Corporation, ATxmega16A4 Datasheet - Page 29

• Manufacturer Part Number: ATxmega16A4
• Manufacturer: Atmel Corporation

Specifications of ATxmega16A4

• Flash (kbytes): 16 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Speed: No
• Usb Interface: No
• Spi: 7
• Twi (i2c): 2
• Uart: 5
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 3.3
• Eeprom (bytes): 1024
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 16
• Input Capture Channels: 16
• Pwm Channels: 16
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

4.15.12
8077H–AVR–12/09
LOCKBITS - Non-Volatile Memory Lock Bit Register
• Bit 5:2 - Reserved
These bits are reserved and will always be read as zero. For compatibility with future devices,
always write these bits to zero when this register is written.
• Bit 1 - EELOAD: EEPROM Page Buffer Active Loading
The EELOAD status flag indicates that the temporary EEPROM page buffer has been loaded
with one or more data bytes. Immediately after an EEPROM load command is issued and byte is
written to NVMDR, or a memory mapped EEPROM buffer load operation is performed, the
EELOAD flag is set, and it remains set until an EEPROM page write- or a page buffer flush oper-
ation is executed.
• Bit 0 - FLOAD: Flash Page Buffer Active Loading
The FLOAD flag indicates that the temporary Flash page buffer has been loaded with one or
more data bytes. Immediately after a Flash load command has been issues and byte is written to
NVMDR, the FLOAD flag is set, and it remains set until an Application- or Boot page write- or a
page buffer flush operation is executed.
This register is a direct mapping of the NVM Lockbits into the IO Memory Space, in order to
enable direct read access from the application software. Refer to
Memory Lock Bit Register” on page 34
Bit
+0x07
Read/Write
Initial Value
R
7
1
BLBB[1:0]
R
6
1
R
5
1
BLBA[1:0]
for description of the Lock Bits.
R
4
1
R
3
1
BLBAT[1:0]
2
R
1
”LOCKBITS - Non-Volatile
R
1
1
LB[1:0]
XMEGA A
R
0
1
LOCKBITS
29