S1D10605 Epson Electronics America, Inc., S1D10605 Datasheet - Page 547

• Manufacturer Part Number: S1D10605
• Description: S1d15000 Series Lcd Driver With Ram
• Manufacturer: Epson Electronics America, Inc.

[Reference items]
* 1 : Although wide operating voltage range is warranted, an exemption to it is when an access made by MPU is
* 2 : See Figure 21 for the operating voltage range of V
* 3 : A0, D0 to D5, D6 (SCL), D7 (SI), RD (E), WR (R/W), CS, CL, C86, P/S and RES pins. V
* 4 : D0 to D7 pins. I
* 5 : A0, RD (E), WR (R/W), CS, C86, CL and RES pins.
* 6 : It is applicable when D0 to D5, D6 (SCL) and D7 (SI) pins are placed in high impedance.
* 7 : It represents the resistance value to be employed when 0.1V is applied across the output pin SEGn or COMn and
* 8 : For the relationship between the oscillating frequency and frame frequency, refer to Table 6. External inputs
* 9 : Adjustment of the V
* 10 : The built-in reference voltage source of the V
* 11/12 : The built-in oscillation circuit is used. It indicates current consumed by the independent IC when the display
* 12 : These values are applicable when the V
Rev. 1.0a
R
accompanied with radical voltage fluctuations.
supply is used.
V
respective power terminals (V
listed in the standard value space are recommended values.
follower circuit.
ents are supported by the S1D15A06; (1) Approximately –0.1%/ C and (2) External input.
is turned on. Current consumption of the S1D15A06 indicated here is one when the 1/6 bias mode is turned on.
It does not includes current consumed due to the LCD panel capacity or wiring capacity (driver output is under
no-load). These values are applicable when an access is not made by MPU.
V
ON
IL
REG
= V
= 0.1V/ I ( I represents the current conducted when 0.1V is applied when the power supply is turned on).
optional temperature gradient of –0.1%/˚C.
SS
to 0.2 V
OH
= –0.25mA, I
DD
0
voltage adjustment circuit must be done within the operating voltage range of the voltage
when V
1
DD
, V
= 1.8V to 2.7V.
OL
2
, V
= 0.25mA when V
3
0
and V4). It must be selected within the operating voltage range (3).
voltage adjusting built-in resistors are used on an S1D15A06 model with
0
voltage adjustment circuit. Two types of V
EPSON
DD
and V
DD
= 1.8V to 2.7V.
0
systems. It is applicable when an external power
S1D15A06 Series
REG
IH
= 0.8 V
temperature gradi-
DD
to V
12–43
DD
,