peb20534h-52 Infineon Technologies Corporation, peb20534h-52 Datasheet - Page 126

• Manufacturer Part Number: peb20534h-52
• Description: Dma Supported Serial Communication Controller With 4 Channels
• Manufacturer: Infineon Technologies Corporation

Note: A slave with push/pull output drivers, which is not selected for transmission, will
Figure 38
6.2.2
The SSC block generates three kinds of interrupts: transmit, receive and error interrupts.
Any of these interrupts can be enabled by setting the corresponding bit of the SSC
Interrupt Mask register SSCIM (refer to section
Page
All interrupt events result in an SSC interrupt vector which is transferred into the
peripheral interrupt queue (refer to section
Data Sheet
355) to ‘1‘. All other bits of this register have to be set to zero.
normally have its output drivers switched. However, in order to avoid possible
conflicts or misinterpretations, it is recommended to always load the slave's
transmit buffer prior to any transfer.
Baudrate
Transmit
Receive
Phase
Error
Error
Error
Error
SSC Interrupt (Vector)
SSC Error Interrupt Control
Register SSCCON
SSCTE
SSCTE
SSCRE
SSCRE
SSCPE
SSCPE
SSCBE
SSCBE
&
&
&
&
126
“SCC Interrupt Vector” on Page
MCS01968
1
Interrupt Vector SSC_IV
“SSC Registers Description” on
Register SSCIM
IMER
ERI
Multi Function Port (MFP)
&
SSCEINT
Interrupt
PEB 20534
Error
PEF 20534
2000-05-30
393).