lpc2917 NXP Semiconductors, lpc2917 Datasheet - Page 35

• Manufacturer Part Number: lpc2917
• Description: Arm9 Microcontroller With Can And Lin
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC2917_19_1
Preliminary data sheet
8.7.5.1 Overview
8.7.5.2 Description
8.7.5 Analog-to-digital converter
Each ADC has two clock areas; a VPB part clocked by CLK_MSCSS_ADCx_VPB (x = 1
or 2) and a control part for the analog section clocked by CLK_ADCx = 1 or 2), see
Section
All clocks are derived from the BASE_MSCSS_CLK, except for CLK_SYS_MSCSS_A
which is derived form BASE_SYS_CLK, and the CLK_ADCx clocks which are derived
from BASE_CLK_ADC. If specific PWM or ADC modules are not used their corresponding
clocks can be switched off.
The MSCSS in the LPC2917/19 includes two 10-bit successive-approximation
analog-to-digital converters.
The key features of the ADC interface module are:
The ADC block diagram,
functionality is divided into two major parts; one part running on the MSCSS Subsystem
clock, the other on the ADC clock. This split into two clock domains affects the behavior
from a system-level perspective. The actual analog-to-digital conversions take place in the
ADC clock domain, but system control takes place in the system clock domain.
A mechanism is provided to modify configuration of the ADC and control the moment at
which the updated configuration is transferred to the ADC domain.
•
•
•
•
•
•
•
•
•
•
•
•
•
CLK_SYS_MSCSS_A clocks the AHB side of the AHB-to-VPB bus bridge
CLK_MSCSS_VPB clocks the subsystem VPB bus
CLK_MSCSS_MTMR0/1 clocks the timers
CLK_MSCSS_PWM0..3 clocks the PWMs.
ADC1 and ADC2: Eight analog inputs; time-multiplexed; measurement range up to
3.3 V
External reference-level inputs
400 ksamples per second at 10-bit resolution up to 1500 ksamples per second at 2-bit
resolution
Programmable resolution from 2-bit to 10-bit
Single analog-to-digital conversion scan mode and continuous analog-to-digital
conversion scan mode
Optional conversion on transition on external start input, timer capture/match signal,
PWM_sync or ‘previous’ ADC
Converted digital values are stored in a register for each channel
Optional compare condition to generate a ‘less than’ or an ‘equal to or greater than’
compare-value indication for each channel
Power-down mode
7.2.2.
Rev. 1.01 — 15 November 2007
Figure
9, shows the basic architecture of each ADC. The ADC
ARM9 microcontroller with CAN and LIN
LPC2917/19
© NXP B.V. 2007. All rights reserved.
35 of 68