xr16c2852ij Exar Corporation, xr16c2852ij Datasheet - Page 33

• Manufacturer Part Number: xr16c2852ij
• Description: 2.97v To 5.5v Dual Uart With 128-byte Fifos
• Manufacturer: Exar Corporation

xr
REV. 2.1.1
MSR[7]: CD Input Status
Normally this bit is the complement of the CD# input. In the loopback mode this bit is equivalent to bit-3 in the
MCR register. The CD# input may be used as a general purpose input when the modem interface is not used.
This is a 8-bit general purpose register for the user to store temporary data. The content of this register is
preserved during sleep mode but becomes 0xFF (default) after a reset or a power off-on cycle.
This register replaces SPR (during a Write) and is accessible only when FCTR[6] = 1.
EMSR[1:0]: Receive/Transmit FIFO Count (Write-Only)
When Scratchpad Swap (FCTR[6]) is asserted, EMSR bits 1-0 controls what mode the FIFO Level Counter is
operating in.
During Alternate RX/TX FIFO Counter Mode, the first value read after EMSR bits 1-0 have been asserted will
always be the RX FIFO Counter. The second value read will correspond with the TX FIFO Counter. The next
value will be the RX FIFO Counter again, then the TX FIFO Counter and so on and so forth.
EMSR[3:2]: Reserved
4.11
4.12
Scratch Pad Register (SPR) - Read/Write
Enhanced Mode Select Register (EMSR)
FCTR[6]
0
1
1
1
1
T
ABLE
EMSR[1] EMSR[0]
12: S
X
0
0
1
1
CRATCHPAD
X
0
1
0
1
33
2.97V TO 5.5V DUAL UART WITH 128-BYTE FIFOS
S
Scratchpad
RX FIFO Counter Mode
TX FIFO Counter Mode
RX FIFO Counter Mode
Alternate RX/TX FIFO
Counter Mode
WAP
S
S
CRATCHPAD IS
ELECTION
XR16C2852