STM32F215RGT6TR STMicroelectronics, STM32F215RGT6TR Datasheet - Page 92

• Manufacturer Part Number: STM32F215RGT6TR
• Description: ARM Microcontrollers - MCU STM32F21 High-Perf M3 1Mb 120 MHz MCU
• Manufacturer: STMicroelectronics

Specifications of STM32F215RGT6TR

• Product Category: ARM Microcontrollers - MCU
• Core: ARM Cortex M3
• Data Bus Width: 32 bit

Electrical characteristics
92/173
Table 38.
Designing hardened software to avoid noise problems
EMC characterization and optimization are performed at component level with a typical
application environment and simplified MCU software. It should be noted that good EMC
performance is highly dependent on the user application and the software in particular.
Therefore it is recommended that the user applies EMC software optimization and
prequalification tests in relation with the EMC level requested for his application.
Software recommendations
The software flowchart must include the management of runaway conditions such as:
●
●
●
Prequalification trials
Most of the common failures (unexpected reset and program counter corruption) can be
reproduced by manually forcing a low state on the NRST pin or the Oscillator pins for 1
second.
To complete these trials, ESD stress can be applied directly on the device, over the range of
specification values. When unexpected behavior is detected, the software can be hardened
to prevent unrecoverable errors occurring (see application note AN1015).
Electromagnetic Interference (EMI)
The electromagnetic field emitted by the device are monitored while a simple application,
executing EEMBC
standard which specifies the test board and the pin loading.
V
V
Symbol
FESD
EFTB
Corrupted program counter
Unexpected reset
Critical Data corruption (control registers...)
Voltage limits to be applied on any I/O pin to
induce a functional disturbance
Fast transient voltage burst limits to be
applied through 100 pF on V
pins to induce a functional disturbance
EMS characteristics
®
code, is running. This emission test is compliant with SAE IEC61967-2
Parameter
Doc ID 17050 Rev 8
DD
and V
SS
V
f
IEC 61000-4-2
V
f
IEC 61000-4-2
HCLK
HCLK
DD
DD
= 3.3 V, LQFP100, T
= 3.3 V, LQFP100, T
= 75 MHz, conforms to
= 75 MHz, conforms to
Conditions
A
A
= +25 °C,
= +25 °C,
STM32F21xxx
Level/
Class
2B
4A