ZLF645S0Q2032G Maxim Integrated, ZLF645S0Q2032G Datasheet - Page 145

• Manufacturer Part Number: ZLF645S0Q2032G
• Description: 8-bit Microcontrollers - MCU Crimzon Flash Infrared MCU
• Manufacturer: Maxim Integrated

Specifications of ZLF645S0Q2032G

• Core: Z8
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 8 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 1 KB
• On-chip Adc: No
• Operating Supply Voltage: 2 V to 3.6 V
• Package / Case: QFN-EP-20
• Mounting Style: SMD/SMT
• Interface Type: UART
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Number Of Programmable I/os: 5
• Number Of Timers: 2 x 8 bit, 1 x 16 bit
• On-chip Dac: No
• Processor Series: ZLF645
• Program Memory Type: Flash
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2 V

Reset and Power Management
19-4572; Rev 0; 4/09
Table 66. Reset and Power Management Registers
12-Bit
D0C
F0A
F0B
F0C
F0D
Note:
Address (Hex)
Bank 8-Bit
D
F
F
F
F
The ZLF645 MCU provides the following reduced-power modes, power monitoring, and
reset features:
•
•
•
•
•
•
•
For supply current values under various conditions, see
Figure 43
registers for reset and power management features. Some features are affected by registers
described in other chapters.
0C
0A
0B
0C
0D
Voltage Brownout Standby—Stops the oscillator and internal clock when the power
level drops below the VBO low voltage detect point. Initiates a power-on reset when
power is restored above the VBO detect point.
STOP Mode—Stops the clock and oscillator, reduces the MCU supply current to a
very low level until a power-on reset or Stop Mode Recovery occurs.
HALT Mode—Stops the internal clock to the CPU until an enabled interrupt request
is received.
Voltage Detection—Optionally sets a flag if a low- or high-voltage condition occurs.
The low-voltage detection flag can generate an interrupt request, if enabled.
Power-On Reset—Starts the oscillator and internal clock, and initializes the system to
its power-on reset defaults.
Watchdog Timer—Optionally generates a Power-On Reset if the program fails to 
execute the WDT instruction within a specified time interval.
Stop Mode Recovery—Restarts the oscillator and internal clock, and initializes most
of the system to its power-on reset defaults. Some register values are not reset by a 
Stop Mode Recovery.
on page 138 displays the Power-On Reset sources.
Register Description
Low-Voltage Detection Register
Stop Mode Recovery Register 4
Stop Mode Recovery Register
Stop Mode Recovery Register 1
Stop Mode Recovery Register 2
Mnemonic
LVD
SMR4
SMR
SMR1
SMR2
DC Characteristics
ZLF645 Series Flash MCUs
Table 66
Reset and Power Management
Product Specification
Reset
1 1 1 1 _100 0 b
XXX0 _000 0 b
0 0 1 0 _00 0 0 b
00h
X0 X0 _00XXb
lists control
on page 165.
Page No
140
156
146
150
152
137