PCA9632DP1,118 NXP Semiconductors, PCA9632DP1,118 Datasheet - Page 8

• Manufacturer Part Number: PCA9632DP1,118
• Description: IC LED DRIVER RGBA 8-TSSOP
• Manufacturer: NXP Semiconductors
• Type: RGBA LED Driverr

Specifications of PCA9632DP1,118

• Package / Case: 8-TSSOP
• Topology: Open Drain, PWM
• Number Of Outputs: 4
• Internal Driver: Yes
• Type - Primary: Backlight, LED Blinker
• Type - Secondary: RGBA
• Frequency: 1MHz
• Voltage - Supply: 2.3 V ~ 5.5 V
• Voltage - Output: 5.5V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Current - Output / Channel: 25mA
• Internal Switch(s): Yes
• Number Of Segments: 4
• Low Level Output Current: 100000 uA
• Operating Supply Voltage: 2.3 V to 5.5 V
• Maximum Supply Current: 150 uA
• Maximum Power Dissipation: 400 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Efficiency: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 935284899118; PCA9632DP1-T; PCA9632DP1-T

NXP Semiconductors
PCA9632_3
Product data sheet
7.1.4 Software reset I
7.2 Control register
The address shown in
performed by the master. The Software Reset address (SWRST Call) must be used with
R/W = 0. If R/W = 1, the PCA9632 does not acknowledge the SWRST. See
“Software reset”
Remark: The Software Reset I
as a regular I
Following the successful acknowledgement of the slave address, LED All Call address or
LED Sub Call address, the bus master will send a byte to the PCA9632, which will be
stored in the Control register.
The lowest 4 bits are used as a pointer to determine which register will be accessed
(D[3:0]). The highest 3 bits are used as Auto-Increment flag and Auto-Increment options
(AI[2:0]). Bit 4 is unused and must be programmed with zero (0) for proper device
operation.
When the Auto-Increment flag is set (AI2 = 1), the four low order bits of the Control
register are automatically incremented after a read or write. This allows the user to
program the registers sequentially. Four different types of Auto-Increment are possible,
depending on AI1 and AI0 values.
Fig 7.
Fig 8.
Software reset address
reset state = 80h
Remark: The Control register does not apply to the Software Reset I
Control register
2
C-bus slave address or as an LED All Call or LED Sub Call address.
for more detail.
2
C-bus address
Figure 7
Rev. 03 — 15 July 2008
AI2 AI1 AI0
Auto-Increment flag
0
2
is used when a reset of the PCA9632 needs to be
C-bus address is a reserved address and cannot be used
Auto-Increment options
0
0
0
0
D3
0
register address
4-bit Fm+ I
D2
1
002aab416
D1
002aab296
1
R/W
D0
0
2
C-bus low power LED driver
2
C-bus address.
PCA9632
© NXP B.V. 2008. All rights reserved.
Section 7.5
8 of 38