SE97TP,147 NXP Semiconductors, SE97TP,147 Datasheet - Page 12

• Manufacturer Part Number: SE97TP,147
• Description: IC TEMP SENSOR DIMM 8-HWSON
• Manufacturer: NXP Semiconductors

Specifications of SE97TP,147

• Function: Temp Monitoring System (Sensor)
• Topology: ADC (Sigma Delta), Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -40°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: Yes
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-WSON (Exposed Pad), 8-HWSON
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4730-2; 935286725147

NXP Semiconductors
SE97_7
Product data sheet
7.4.1 What temperature is read when conversion is in progress
7.4 Conversion rate
7.5 Power-up default condition
7.6 Device initialization
The conversion time is the amount of time required for the ADC to complete a
temperature measurement for the local temperature sensor. The conversion rate is the
inverse of the conversion period which describes the number of cycles the temperature
measurement completes in one second—the faster the conversion rate, the faster the
temperature reading is updated. The SE97’s conversion rate is at least 8 Hz or 125 ms.
The SE97 has been designed to ensure a valid temperature is always available. When a
read to the temperature register is initiated through the SMBus, the device checks to see if
the temperature conversion process (Analog-to-Digital conversion) is complete and a new
temperature is available:
It is possible that while SMBus Master is reading the temperature register, a new
temperature conversion completes. However, this will not affect the data (MSB or LSB)
that is being shifted out. On the next read of the temperature register, the new
temperature value will be shifted out.
After power-on, the SE97 is initialized to the following default condition:
SE97 temperature sensors have programmable registers, which, upon power-up, default
to zero. The open-drain EVENT output is default to being disabled, comparator mode and
active LOW. The alarm trigger registers default to being unprotected. The configuration
registers, upper and lower alarm boundary registers and critical temperature window are
defaulted to zero and need to be programmed to the desired values. SMBus TIMEOUT
•
•
•
•
•
•
•
•
•
•
– Work-around: Always clear the EVENT output before temperature exceeds the
– SE97B will keep EVENT asserted after the temperature drops below the critical
If the temperature conversion process is complete, then the new temperature value is
sent out on the SMBus.
If the temperature conversion process in not complete, then the previous temperature
value is sent out on the SMBus.
Starts monitoring local sensor
EVENT register is cleared; EVENT output is pulled HIGH by external pull-ups
EVENT hysteresis is defaulted to 0 °C
Command pointer is defaulted to ‘00h’
Critical Temp, Alarm Temperature Upper and Lower Boundary Trip register are
defaulted to 0 °C
Capability register is defaulted to ‘0017h’ for the B grade
Operational mode: comparator
SMBus register is defaulted to ‘00h’
critical temperature.
temperature until a Clear EVENT command de-asserts EVENT.
Rev. 07 — 29 January 2010
DDR memory module temp sensor with integrated SPD, 3.3 V
© NXP B.V. 2010. All rights reserved.
SE97
12 of 55