P0304 Terasic Technologies Inc, P0304 Datasheet - Page 33

• Manufacturer Part Number: P0304
• Description: DE2-70 CALL FOR ACADEMIC PRICING
• Manufacturer: Terasic Technologies Inc
• Type: FPGAr

Specifications of P0304

• Contents: DE2-70 Board, Power Supply, Cables, Plastic cover and software
• For Use With/related Products: Cyclone II 2C70
• For Use With: P0033 - BOARD ADAPTER HSMC TO GPIOP0006 - BOARD ADAPTER THDB-SUMP0001 - MODULE DIGITAL CAMERA 5MP (D5M)P0307 - KIT DEV 4.3" LCD TOUCH PANEL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: DE2-70

This chapter gives instructions for using the DE2-70 board and describes each of its I/O devices.
5.1 Configuring the Cyclone II FPGA
The procedure for downloading a circuit from a host computer to the DE2-70 board is described in
the tutorial Quartus II Introduction. This tutorial is found in the DE2_70_tutorials folder on the
DE2-70 System CD-ROM. The user is encouraged to read the tutorial first, and to treat the
information below as a short reference.
The DE2-70 board contains a serial EEPROM chip that stores configuration data for the Cyclone II
FPGA. This configuration data is automatically loaded from the EEPROM chip into the FPGA each
time power is applied to the board. Using the Quartus II software, it is possible to reprogram the
FPGA at any time, and it is also possible to change the non-volatile data that is stored in the serial
EEPROM chip. Both types of programming methods are described below.
The sections below describe the steps used to perform both JTAG and AS programming. For both
methods the DE2-70 board is connected to a host computer via a USB cable. Using this connection,
the board will be identified by the host computer as an Altera USB Blaster device. The process for
installing on the host computer the necessary software device driver that communicates with the
USB Blaster is described in the tutorial Getting Started with Altera's DE2-70 Board. This tutorial is
available on the DE2-70 System CD-ROM.
1. JTAG programming: In this method of programming, named after the IEEE standards Joint
2. AS programming: In this method, called Active Serial programming, the configuration bit
Test Action Group, the configuration bit stream is downloaded directly into the Cyclone II
FPGA. The FPGA will retain this configuration as long as power is applied to the board;
the configuration is lost when the power is turned off.
stream is downloaded into the Altera EPCS16 serial EEPROM chip. It provides
non-volatile storage of the bit stream, so that the information is retained even when the
power supply to the DE2-70 board is turned off. When the board's power is turned on, the
configuration data in the EPCS16 device is automatically loaded into the Cyclone II
FPGA.
Using the DE2-70 Board
Chapter 5
30
DE2-70 User Manual