DEMO908QB8 Freescale Semiconductor, DEMO908QB8 Datasheet - Page 6

• Manufacturer Part Number: DEMO908QB8
• Description: BOARD DEMO FOR MC68HC908QB8
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO908QB8

• Contents: *
• Processor To Be Evaluated: MC908QB8
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Freescale
• Core Architecture: HC08
• Core Sub-architecture: HC08
• Silicon Core Number: MC68HC908
• Silicon Family Name: HC08Q
• Kit Contents: MC68HC908QB8, Cables, Guides
• Rohs Compliant: No
• For Use With/related Products: MC68HC908QB8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

D E M O 9 0 8 Q B 8
REFERENCES
Reference documents are provided on the support CD in Acrobat Reader format.
DEMO908QB8_UG.pdf
DEMO908QB8_SCH_C.pdf
DEMO908QB8QS.pdf
DEMO908QB8_LED.zip
DEMO908QB8_ATD.zip
AN2627.pdf
GETTING STARTED
To get started quickly, please refer to the DEMO908QB8 Quick Start Guide. This quick start
will show the user how to connect the board to the PC, run a LED test program, install the cor-
rect version of CodeWarrior Development Studio, and load an Analog to Digital (ATD) test pro-
gram using CodeWarrior.
OPERATING MODES
The DEMO908QB8 board operates in two basic modes Run Mode, or MON08 Debug Mode.
Run Mode supports user application operation from Power-On or Reset. MON08 Debug Mode
supports the development and debug of applications via the MON08 embedded debug
monitor. See the related sections below for quickly starting the board in the desired operation
mode.
The board has been preloaded with a demonstration program. The demo program operates in
the Run Mode. The +5V LED will light when power is applied to the board.
RUN Mode
Run mode allows user application to function when power is applied to the board. Use the
following settings to configure the DEMO908QB8 board for RUN Mode to get started quickly.
1. Connect a serial communication cable (not inlcuded) between the board and a host PC if
2. Connect auxiliary equipment to board as required by application.
3. Configure the board option jumpers for run mode.
needed for the application. Launch supporting host communication software as needed.
DEMO908QB8 User Guide (this document)
DEMO908QB8 Board Schematic Rev. C
DEMO908QB8 Quick Start Guide
CodeWarrior LED Demonstration application
CodeWarrior ATD Demonstration application
Cycle-by-Cycle Instruction Details for HC08 MCU’s
6
M A R C H
1 8 ,
2 0 0 5