SAM7X128 Atmel Corporation, SAM7X128 Datasheet - Page 119

• Manufacturer Part Number: SAM7X128
• Manufacturer: Atmel Corporation

Specifications of SAM7X128

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 62
• Ext Interrupts: 62
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 3
• Can: 1
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

20. Fast Flash Programming Interface (FFPI)
20.1
20.2
20.2.1
6120I–ATARM–06-Apr-11
Overview
Parallel Fast Flash Programming
Device Configuration
The Fast Flash Programming Interface provides two solutions - parallel or serial - for high-vol-
ume programming using a standard gang programmer. The parallel interface is fully
handshaked and the device is considered to be a standard EEPROM. Additionally, the parallel
protocol offers an optimized access to all the embedded Flash functionalities. The serial inter-
face uses the standard IEEE 1149.1 JTAG protocol. It offers an optimized access to all the
embedded Flash functionalities.
Although the Fast Flash Programming Mode is a dedicated mode for high volume programming,
this mode not designed for in-situ programming.
In Fast Flash Programming Mode, the device is in a specific test mode. Only a certain set of pins
is significant, the rest of the PIOs are used as inputs with a pull-up. The crystal oscillator is in
bypass mode. Other pins must be left unconnected.
Figure 20-1. Parallel Programming Interface
MODE[3:0]
DATA[15:0]
0 - 50MHz
NVALID
VDDIO
VDDIO
VDDIO
NCMD
NOE
RDY
PGMD[15:0]
TST
PGMEN0
PGMEN1
PGMNCMD
PGMRDY
PGMNOE
PGMNVALID
PGMM[3:0]
XIN
SAM7X512/256/128
VDDCORE
VDDIO
VDDPLL
VDDFLASH
GND
119