SAM7X128 Atmel Corporation, SAM7X128 Datasheet - Page 613

• Manufacturer Part Number: SAM7X128
• Manufacturer: Atmel Corporation

Specifications of SAM7X128

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 62
• Ext Interrupts: 62
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 3
• Can: 1
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

38.3.2
6120I–ATARM–06-Apr-11
Peripheral Power Consumption in Active Mode
These figures represent the power consumption typically measured on the power supplies..
Table 38-6.
Notes:
Table 38-7.
Note:
Mode
Active
(SAM7X512/256/128)
Ultra Low Power
Peripheral
PIO Controller
USART
UDP
PWM
TWI
SPI
SSC
Timer Counter Channels
CAN
ARM7TDMI
EMAC
System Peripherals (SAM7X512/256/128)
1. “Flash is in standby mode”, means the Flash is not accessed at all.
2. Low power consumption figures stated above cannot be guaranteed when accesing the Flash
1. Note: V
in Ultra Low Power mode. In order to meet given low power consumption figures, it is recom-
mended to either stop the processor or jump to SRAM.
Power Consumption for Different Modes
Power Consumption on V
(2)
DDCORE
= 1.85V, T
Conditions
Voltage regulator is on.
Brown Out Detector is activated.
Flash is read.
ARM Core clock is 50MHz.
Analog-to-Digital Converter activated.
All peripheral clocks activated.
USB transceiver enabled.
onto AMP1
onto AMP2
Voltage regulator is in Low-power mode.
Brown Out Detector is de-activated.
Flash is in standby mode.
ARM Core in idle mode.
MCK @ 500Hz.
Analog-to-Digital Converter de-activated.
All peripheral clocks de-activated.
USB transceiver disabled.
DDM and DDP pins connected to ground.
onto AMP1
onto AMP2
A
= 25° C
DDCORE
(1)
Consumption (Typ)
(1)
160
120
200
12
28
20
16
16
32
75
SAM7X512/256/128
5
6
Consumption
44
43
26
12
µA/MHz
Unit
Unit
mA
µA
613