SAM3X8C Atmel Corporation, SAM3X8C Datasheet - Page 282

• Manufacturer Part Number: SAM3X8C
• Manufacturer: Atmel Corporation

17.4.7.2
17.4.8
Figure 17-7. Wake Up Source
282
282
WKUP15
WKUP0
WKUP1
FWUP
SAM3X/A
SAM3X/A
Wake Up Sources
Brownout Detector Reset
rtc_alarm
rtt_alarm
sm_int
Falling/Rising
Falling/Rising
Falling/Rising
WKUPT15
WKUPT0
WKUPT1
Detector
Detector
Detector
Detector
Falling
Edge
Edge
Edge
Edge
The brownout detector provides the bodcore_in signal to the SUPC which indicates that the volt-
age regulation is operating as programmed. If this signal is lost for longer than 1 slow clock
period while the voltage regulator is enabled, the Supply Controller can assert vddcore_nreset.
This feature is enabled by writing the bit, BODRSTEN (Brownout Detector Reset Enable) to 1 in
the Supply Controller Mode Register (SUPC_MR).
If BODRSTEN is set and the voltage regulation is lost (output voltage of the regulator too low),
the vddcore_nreset signal is asserted for a minimum of 1 slow clock cycle and then released if
bodcore_in has been reactivated. The BODRSTS bit is set in the Supply Controller Status Reg-
ister (SUPC_SR) so that the user can know the source of the last reset.
Until bodcore_in is deactivated, the vddcore_nreset signal remains active.
The wake up events allow the device to exit backup mode. When a wake up event is detected,
the Supply Controller performs a sequence which automatically reenables the core power
supply.
SMEN
RTCEN
RTTEN
WKUPEN15
WKUPEN0
WKUPEN1
FWUPEN
WKUPIS0
WKUPIS1
WKUPIS15
SLCK
SLCK
FWUPDBC
WKUPDBC
Debouncer
Debouncer
WKUPS
FWUP
11057A–ATARM–17-Feb-12
11057A–ATARM–17-Feb-12
Core
Supply
Restart