UPD78F9234MC-5A4-A Renesas Electronics America, UPD78F9234MC-5A4-A Datasheet - Page 279

• Manufacturer Part Number: UPD78F9234MC-5A4-A
• Description: MCU 8BIT 8KB FLASH 30PIN
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9234MC-5A4-A

• Core Processor: 78K0S
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

19.6 Pin Connection on Board
provided on the target system. First provide a function that selects the normal operation mode or flash memory
programming mode on the board.
the same status as immediately after reset. Therefore, if the external device does not recognize the state immediately
after reset, the pins must be processed as described below.
19.6.1 X1 and X2 pins
pins are connected to an external device, a signal conflict occurs. To prevent the conflict of signals, isolate the
connection with the external device.
and thus communication may be disabled depending on the capacitor capacitance.
connection with the capacitor during flash programming.
when it is difficult to isolate the resonator, while a crystal or ceramic resonator is selected as the system clock.
To write the flash memory on-board, connectors that connect the dedicated flash memory programmer must be
When the flash memory programming mode is set, all the pins not used for programming the flash memory are in
The state of the pins in the self programming mode is the same as that in the HALT mode.
The X1 and X2 pins are used as the serial interface of flash memory programming. Therefore, if the X1 and X2
Similarly, when a capacitor is connected to the X1 and X2 pins, the waveform during communication is changed,
Perform the following processing (1) and (2) when on-board programming is performed with the resonator mounted,
(1) Mount the minimum-possible test pads between the device and the resonator, and connect the programmer via
(2) Set the oscillation frequency of the communication clock for writing using the programming GUI of the
the test pad. Keep the wiring as short as possible (refer to Figure 19-4 and Table 19-3).
dedicated flash memory programmer. Research the series/parallel resonant and antiresonant frequencies of
the resonator used, and set the oscillation frequency so that it is outside the range of the resonant frequency
10% (refer to Figure 19-5 and Table 19-4).
High-speed internal oscillation clock
External clock
Crystal/ceramic oscillation
clock
Table 19-3. Clock to Be Used and Mounting of Test Pads
Figure 19-4. Example of Mounting Test Pads
Clock to Be Used
CHAPTER 19 FLASH MEMORY
Before resonator is mounted
After resonator is mounted
User’s Manual U17446EJ5V0UD
V
SS
X1
Test pad
X2
Not required
Required
Mounting of Test Pads
Make sure to isolate the
277