ATAM893T-TKS Atmel, ATAM893T-TKS Datasheet - Page 12

• Manufacturer Part Number: ATAM893T-TKS
• Description: IC MON TIRE-PRESS ATARX9X SER
• Manufacturer: Atmel
• Series: MARC4r

Specifications of ATAM893T-TKS

• Core Processor: MARC4
• Core Size: 4-Bit
• Speed: 4MHz
• Connectivity: SSI (2-Wire, 3 Wire)
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 16
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: EEPROM
• Eeprom Size: 64 x 16
• Ram Size: 256 x 4
• Voltage - Supply (vcc/vdd): 1.8 V ~ 6.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 20-SOIC (5.3mm Width), 20-SO, 20-SOEIAJ
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Data Converters: -

4.3.1
12
ATAM893-D
Power-on Reset and Brown-out Detection
Figure 4-7.
The ATAM893-D has a fully integrated power-on reset and brown-out detection circuitry. For
reset generation no external components are needed.
These circuits ensure that the core is held in the reset state until the minimum operating supply
voltage has been reached. A reset condition will also be generated should the supply voltage
drop momentarily below the minimum operating level except when a power down mode is acti-
vated (the core is in SLEEP mode and the peripheral clock is stopped). In this power-down
mode the brown-out detection is disabled. Two values for the brown-out voltage threshold are
programmable via the BOT bit in the SC register.
A power-on reset pulse is generated by a V
A brown-out reset pulse is generated when V
values for the brown-out voltage threshold are programmable via the BOT bit in the SC register.
When the controller runs in the upper supply voltage range with a high system clock frequency,
the high threshold must be used. When it runs with a lower system clock frequency, the low
threshold and a wider supply voltage range may be chosen. For further details, see the electrical
specification and the SC register description for BOT programming.
Reset Configuration
NRST
V
DD
Pull-up
DD
DD
rise across the default BOT voltage level (1.7 V).
falls below the brown-out voltage threshold. Two
CL
CL = SYSCL/4
res
Watch-
supervisor
Brown-out
Power-on
Ext. clock
detection
dog
reset
Reset
timer
res
Internal
CWD
ExIn
V
V
V
reset
V
DD
SS
DD
SS
4680C–4BMCU–01/05