C500LK009V1 Omron, C500LK009V1 Datasheet - Page 40
C500LK009V1
Manufacturer Part Number
C500LK009V1
Description
PC LINK UNIT
Manufacturer
Omron
Datasheet
1.C500LK009V1.pdf
(174 pages)
Specifications of C500LK009V1
Leaded Process Compatible
No
Peak Reflow Compatible (260 C)
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
- Current page: 40 of 174
- Download datasheet (961Kb)
Cable Connection
3-4
3-4-1 Coaxial Cable
Required Components
Connection Procedure
26
Cable Connection
1, 2, 3...
1, 2, 3...
Note
SYSMAC LINK Units can be connected with either coaxial cable or optical
fiber cable. This section describes the procedures required to connect both
types of cable.
The diagram below shows a SYSMAC LINK System connected by coaxial
cables.
The connection procedure is described briefly below.
Connector
1. Coaxial cable and connectors:
2. F Adapters (C1000H-CE001):
3. Terminator (C1000H-TER01):
1. Turn off the power supply to the PC before connecting the cables.
2. Leave the protective sticker in place on the Unit when wiring to prevent wire
3. Remove the protective sticker after completion of wiring before turning on
1. Install connectors on each end of the cables.
2. Connect the Terminators to the F Adapters at the ends of the network (i.e., to
Use 5C-2V coaxial cable designed for indoor use. Install connectors on
each end of the cable. Cables must be continuous lengths only. No interven-
ing cable connectors or breaks are permitted.
Coaxial cables are connected to the SYSMAC LINK Units via F Adapters.
One F Adapter is included as an accessory with SYSMAC LINK Units that
use coaxial cables (C1000H-SLK21-V1 and C200HW-SLK23/24). An
Attachment Stirrup (C200H-TL001) is also included with the C200HW-
SLK23/24.
Two Terminators (sold separately) are required for the F Adapters at the
ends of the network.
clippings and other foreign matter from entering the Unit during the wiring
procedure.
power to the Unit. If Unit is operated with the protective sticker in place, the
Unit may overheat, causing operational errors.
the unused connectors at the last Unit on each end). Hold the connector in
one hand and press the resistor into it firmly with the other.
F Adapter
Terminator
5C-2V
coaxial cable
Terminator
Section 3-4
Related parts for C500LK009V1
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
PROGRAMMING CONSOLE ADAPTER
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
TEACH BOX I/F CBL FOR NC
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: