NT20S-KBA01 Omron, NT20S-KBA01 Datasheet - Page 14

• Manufacturer Part Number: NT20S-KBA01
• Description: CHEM RESISTANT CVR FOR NT21
• Manufacturer: Omron

Specifications of NT20S-KBA01

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

xvi
S Direct exposure to wind and rain (outdoor sites)
S Strong ultra-violet irradiation
Take adequate measures to ensure shielding if the NT20S is used at a location
subject to any of the following conditions.
S Static electricity, or noise from other equipment
S Strong electric or magnetic fields
S Nearby power cables
S Potential exposure to radioactivity
S Do not install at a site exposed to chemicals, steam, etc, or subject to excessive
S Do not install the unit at locations where the ambient temperature goes outside
S Do not install the unit directly above equipment that generates a lot of heat
S Take the following points into account in order to prevent noise
S Secure sufficient space for ventilation.
S Do not install in sites subject to severe vibration or strong shocks.
S Install at a distance from high-voltage devices and power equipment in consid-
S Press touch switches with a force of no greater than 30 N.
S If touch switches are pressed in rapid succession, their inputs may not be suc-
S Do not press touch switches carelessly while the backlight is off or while noth-
Confirm system safety carefully before changing monitor data.
To ensure system safety, be sure to periodically read the PT operating status bit
from the host in order to ensure that the PT is always operating normally.
airborne dust.
the range 0 to 50_C or where the relative humidity goes outside the range 35 to
85% RH.
If the ambient temperature exceeds the range indicated above, install a fan or
an air conditioner.
(heaters, transformers, large capacity resistors, etc.)
eration of operability and safety during maintenance.
cessfully received.
Confirm that the input of a touch switch has been successfully received before
moving on to the next operation.
ing is displayed on the screen. Otherwise the system may operate unpredict-
ably.
Only press touch switches after confirming system safety.
(1) Avoid installing the unit in panels in which high-voltage equipment is
(2) Install the unit at a distance of at least 200 mm from power lines.
(3) If the unit is installed next to equipment that generates a strong electric
also installed.
or magnetic field (solenoids, etc.), provide a gap of at least 40 mm.