CVM1-PA208 Omron, CVM1-PA208 Datasheet - Page 72

• Manufacturer Part Number: CVM1-PA208
• Description: CV/CVM1 POWER SUPPLY, AC
• Manufacturer: Omron

Specifications of CVM1-PA208

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3-5
56
CPU and I/O Connecting Cables
CPU and I/O Connecting Cables
Note
The dimensions shown in the following diagram are required for the CPU and I/O
Connecting Cables when they are connected to the I/O Control Units and I/O
Interface Units. Be sure to allow sufficient space for the cables.
The total Connecting Cable length for any one series of Racks must be 50 m or
less. Plan installation locations and choose the Connecting Cables accordingly.
Do not place CPU or I/O Connecting Cables in the same duct as I/O power or
high-voltage lines.
Press in firmly on the connectors and be sure that the connectors on the CPU
and I/O Connecting Cables are locked into place on the I/O Control Unit and I/O
Interface Units. Bus errors, I/O setting errors, and other errors will occur if the
cables are not connected properly.
The connector lock and cable pull strength for the CPU Connecting Cables, I/O
Connecting Cables and Programming Device Cables are 5 kg
f.
Always press in on the locks at the top and bottom of the connectors before re-
moving a cable connector.
Connect the CV500-TER01 Terminating Resistor Unit to the unused connectors
on the last I/O Interface Unit and to any unused connectors on the I/O Control
Unit. Two Terminating Resistor Units are provided with the CV500-IC101/IC201
I/O Control Unit.
1. The total Connecting Cable length for any one series of Racks must be 50 m
2. Press in firmly on the connectors until they lock into place.
3. Always press in on the locks at the top and bottom of the connectors before
or less.
removing a cable connector.
I/O Control Unit
Approx.
140 mm
I/O Interface Unit
Approx.
140 mm
Section
3-5