GD82559ER 824184 Intel, GD82559ER 824184 Datasheet - Page 13
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
GD82559ER 824184
Manufacturer Part Number
GD82559ER 824184
Description
Manufacturer
Intel
Datasheet
1.GD82559ER_824184.pdf
(94 pages)
Specifications of GD82559ER 824184
Operating Supply Voltage (typ)
3.3V
Operating Supply Voltage (min)
3V
Operating Temperature Classification
Commercial
Mounting
Surface Mount
Pin Count
196
Lead Free Status / RoHS Status
Not Compliant
3.
3.1
3.2
3.2.1
Datasheet
Signal Descriptions
Signal Type Definitions
PCI Bus Interface Signals
Address and Data Signals
IN
OUT
T/S
S/T/S
O/D
A/I
A/O
B
AD[31:0]
C/BE[3:0]#
PAR
Type
Symbol
Input
Output
Tri-State
Sustained Tri-State
Open Drain
Analog Input
Analog Output
Bias
T/S
T/S
T/S
Name
Type
Address and Data. The address and data lines are multiplexed on
the same PCI pins. A bus transaction consists of an address phase
followed by one or more data phases. During the address phase, the
address and data lines contain the 32-bit physical address. For I/O,
this is a byte address; for configuration and memory, it is a Dword
address. The 82559ER uses little-endian byte ordering (in other
words, AD[31:24] contain the most significant byte and AD[7:0]
contain the least significant byte). During the data phases, the address
and data lines contain data.
Command and Byte Enable. The bus command and byte enable
signals are multiplexed on the same PCI pins. During the address
phase, the C/BE# lines define the bus command. During the data
phase, the C/BE# lines are used as Byte Enables. The Byte Enables
are valid for the entire data phase and determine which byte lanes
carry meaningful data.
Parity. Parity is even across AD[31:0] and C/BE[3:0]# lines. It is stable
and valid one clock after the address phase. For data phases, PAR is
stable and valid one clock after either IRDY# is asserted on a write
transaction or TRDY# is asserted on a read transaction.Once PAR is
valid, it remains valid until one clock after the completion of the current
data phase. The master drives PAR for address and write data
phases; and the target, for read data phases.
The output pin is a Totem Pole Output pin and is a standard
active driver.
The tri-state pin is a bidirectional, input/output pin.
The sustained tri-state pin is an active low tri-state signal owned
and driven by one agent at a time. The agent asserting the S/T/
S pin low must drive it high at least one clock cycle before
floating the pin. A new agent can only assert an S/T/S signal low
one clock cycle after it has been tri-stated by the previous
owner.
The open drain pin allows multiple devices to share this signal
as a wired-OR.
The analog input pin is used for analog input signals.
The analog output pin is used for analog output signals.
The bias pin is an input bias.
The input pin is a standard input only signal.
Name and Function
Description
Networking Silicon —GD82559ER
7