GD82559ER 824184 Intel, GD82559ER 824184 Datasheet - Page 34

• Manufacturer Part Number: GD82559ER 824184
• Manufacturer: Intel

Specifications of GD82559ER 824184

• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 3V
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 196
• Lead Free Status / RoHS Status: Not Compliant

GD82559ER — Networking Silicon
4.2.5.2
4.3
4.4
28
Note: Flash accesses must always be assembled or disassembled by the 82559ER whenever the access is
Link Status Change Event
The 82559ER link status indication circuit is capable of issuing a PME on a link status change from
a valid link to an invalid link condition or vice versa. The 82559ER reports a PME link status event
in all power states. The PME# signal is gated by the PME Enable bit in the PMCSR and the CSMA
Configure command, which is described in the Software Developer’s Manual.
Parallel Flash Interface
The 82559ER’s parallel interface is used primarily as a Flash interface. The 82559ER supports a
glueless interface to an 8-bit wide, 128 Kbyte, parallel memory device.
The Flash (or boot PROM) is read from or written to whenever the host CPU performs a read or a
write operation to a memory location that is within the Flash mapping window. All accesses to the
Flash, except read accesses, require the appropriate command sequence for the device used. (Refer
to the specific Flash data sheet for more details on reading from or writing to the Flash device.) The
accesses to the Flash are based on a direct decode of CPU accesses to a memory window defined in
either the 82559ER Flash Base Address Register (PCI Configuration space at offset 18H) or the
Expansion ROM Base Address Register (PCI Configuration space at offset 30H). The 82559ER
asserts control to the Flash when it decodes a valid access.
The 82559ER supports an external Flash memory (or boot PROM) of up to 128 Kbyte. The
Expansion ROM BAR can be separately disabled by setting the corresponding bit in the EEPROM,
word AH.
greater than a byte-wide access. Due to slow access times to a typical Flash and to avoid violating
PCI bus holding specifications (no more than 16 wait states inserted for any cycles that are not
system initiation cycles), the maximum data size is either one word or one byte for a read operation
and one byte only for a write operation.
Serial EEPROM Interface
The serial EEPROM stores configuration data for the 82559ER and is a serial in/serial out device.
The 82559ER supports a either a 64 register or 256 register size EEPROM and automatically
detects the EEPROM’s size. The EEPROM should operate at a frequency of at least 1 MHz.
Datasheet