ISP1507EBS,518 NXP Semiconductors, ISP1507EBS,518 Datasheet - Page 22

• Manufacturer Part Number: ISP1507EBS,518
• Description: RF Transceiver USB 2.0 ULPI TRNSCVR
• Manufacturer: NXP Semiconductors

Specifications of ISP1507EBS,518

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant
• Other names: 935285498518 ISP1507EBS-T

NXP Semiconductors
ISP1507E_ISP1507F_1
Product data sheet
reset has completed. After every reset, an RXCMD is sent to the link to update USB status
information. After this sequence, the ULPI bus is ready for use and the link can start USB
operations.
When the internal PLL is stable, the ISP1507 will drive a 60 MHz clock out from the
CLOCK pin when DIR deasserts. An example start-up sequence is shown in
The recommended power-up sequence for the link is as follows:
The ULPI is ready for use.
1. The link waits for 1 ms, ignoring all the ULPI pin status.
2. The link may start to detect the DIR status level. If DIR is detected as LOW for three
clock cycles, the link may send a RESET command.
Rev. 01 — 28 May 2008
ISP1507E; ISP1507F
ULPI HS USB OTG transceiver
© NXP B.V. 2008. All rights reserved.
Figure
21 of 78
6.