STM32W108HBU6 STMicroelectronics, STM32W108HBU6 Datasheet - Page 122

• Manufacturer Part Number: STM32W108HBU6
• Manufacturer: STMicroelectronics

Specifications of STM32W108HBU6

• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Processing Unit: Microprocessor
• Operating Supply Voltage (min): 1.18V
• Operating Supply Voltage (typ): 1.25V
• Operating Supply Voltage (max): 1.32V
• Package Type: VFQFPN EP
• Pin Count: 40
• Mounting: Surface Mount
• Rad Hardened: No
• Lead Free Status / Rohs Status: Supplier Unconfirmed

General-purpose timers
Figure 34. Output compare mode, toggle on OC1
10.1.9
122/208
PWM mode
Pulse width modulation mode allows you to generate a signal with a frequency determined
by the value of the TIMx_ARR register, and a duty cycle determined by the value of the
TIMx_CCRy register.
PWM mode can be selected independently on each channel (one PWM per OCy output) by
writing 110 (PWM mode 1) or 111 (PWM mode 2) in the TIM_OCyM bits in the
TIMx_CCMR1 register. The corresponding buffer register must be enabled by setting the
TIM_OCyBE bit in the TIMx_CCMR1 register. Finally, in up-counting or center-aligned mode
the auto-reload buffer register must be enabled by setting the TIM_ARBE bit in the
TIMx_CR1 register.
Because the buffer registers are only transferred to the shadow registers when an update
event occurs, before starting the counter initialize all the registers by setting the TIM_UG bit
in the TIMx_EGR register.
OCy polarity is software programmable using the TIM_CCyP bit in the TIMx_CCER register.
It can be programmed as active high or active low. OCy output is enabled by the TIM_CCyE
bit in the TIMx_CCER register. Refer to the TIMx_CCER register description in the
Registers section for more details.
In PWM mode (1 or 2), TIMx_CNT and TIMx_CCRy are always compared to determine
whether TIMx_CCRy ≤ TIMx_CNT or TIMx_CNT ≤ TIMx_CCRy,depending on the direction
of the counter. The OCyREF signal is asserted only:
●
●
This allows software to force a PWM output to a particular state while the timer is running.
When the result of the comparison changes, or
When the output compare mode (TIM_OCyM bits in the TIMx_CCMR1 register)
switches from the "frozen" configuration (no comparison, TIM_OCyM = 000) to one of
the PWM modes (TIM_OCyM = 110 or 111).
Doc ID 16252 Rev 7
STM32W108CB, STM32W108HB