LH28F160BVE-BTL90 Sharp Electronics, LH28F160BVE-BTL90 Datasheet - Page 11

• Manufacturer Part Number: LH28F160BVE-BTL90
• Manufacturer: Sharp Electronics

Specifications of LH28F160BVE-BTL90

• Cell Type: NOR
• Density: 16Mb
• Access Time (max): 90ns
• Interface Type: Parallel
• Boot Type: Bottom
• Address Bus: 21/20Bit
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: 0C to 70C
• Package Type: TSOP
• Sync/async: Asynchronous
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8/16Bit
• Number Of Words: 2M/1M
• Supply Current: 30mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / Rohs Status: Not Compliant

SHARP
The
manufacturer code and device code (see Figure 4). Using
the manufacturer and device codes, the system CPU can
3.5 Read Identifier Codes Operation
automatically match the device with its proper algorithms.
L%P-Aol
FFFFF
ooom
oooo2
OOCQI
Figure 4. Device Identifier Code Memory Map
read
identifier
Reserved for Future Implementation
codes
Manufacturer
Device Code
operation
Code
outputs
the
LHF16V09
The Block Erase command requires appropriate command
The CUI does not occupy an addressable memory
on the rising edge of WE# or CE# (whichever goes high
first). Standard microprocessor write timings are used.
Figures 13 and 14 illustrate WE# and CE# controlled write
operations.
4 COMMAND
When the V,, voltage I V,,,,
status register, identifier codes, or blocks are enabled.
Placing V,,,,,,
and word/byte write operations.
Device operations are selected by writing specific
commands into the CUI. Table 4 defines these commands.
Writing commands to the CUI enable reading of device
data and identifier codes. They also control inspection and
clearing of the status register. When V,,=2.lV-3.6V
V,,=V,,,,,,,
and word/byte write.
data and an address within the block to be erased. The
Word/Byte Write command requires the command and
address of the location to be written.
location. It is written when WE# and CE# are active. The
address and data needed to execute a command are latched
3.6 Write
the CUI additionally controls block erasure
on V,, enables successful block erase
DEFINITIONS
Read operations from the
Rev. 1.1
and
9