AT32UC3B0256 Atmel Corporation, AT32UC3B0256 Datasheet - Page 385

• Manufacturer Part Number: AT32UC3B0256
• Manufacturer: Atmel Corporation

Specifications of AT32UC3B0256

• Flash (kbytes): 256 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 60 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 44
• Ext Interrupts: 44
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 4
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32059L–AVR32–01/2012
TXOUTI
FIFOCON
TXOUTI
FIFOCON
TXOUTI shall be cleared by software (by writing a one to the Transmitted OUT Data Interrupt
Clear (TXOUTIC) bit in UPCONnCLR) to acknowledge the interrupt, what has no effect on the
pipe FIFO.
The user then writes into the FIFO (see
DATA)” on page
OUT pipe is composed of multiple banks, this also switches to the next bank. The TXOUTI and
FIFOCON bits are updated in accordance with the status of the next bank.
TXOUTI shall always be cleared before clearing FIFOCON.
The UPSTAn.RWALL bit is set when the current bank is not full, i.e., the software can write fur-
ther data into the FIFO.
Note that if the user decides to switch to the Suspend state (by writing a zero to the
UHCON.SOFE bit) while a bank is ready to be sent, the USBB automatically exits this state and
the bank is sent.
Figure 22-27. Example of an OUT Pipe with one Data Bank
Figure 22-28. Example of an OUT Pipe with two Data Banks and no Bank Switching Delay
SW
SW
write data to CPU
write data to CPU
BANK 0
BANK 0
471) and clears the FIFOCON bit to allow the USBB to send the data. If the
SW
OUT
SW
OUT
SW
(bank 0)
DATA
write data to CPU
”USB Pipe/Endpoint n FIFO Data Register (USBFIFOn-
BANK 1
(bank 0)
DATA
ACK
HW
HW
ACK
SW
OUT
SW
SW
write data to CPU
(bank 1)
DATA
write data to CPU
BANK 0
BANK0
ACK
SW
OUT
385