SAM9G25 Atmel Corporation, SAM9G25 Datasheet - Page 923

• Manufacturer Part Number: SAM9G25
• Manufacturer: Atmel Corporation

Specifications of SAM9G25

• Flash (kbytes): 0 Kbytes
• Pin Count: 247
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 105
• Ext Interrupts: 105
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 3
• Uart: 7
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 12
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: DDR2/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

41.6.4
Figure 41-3. EOCx and DRDY Flag Behavior
11032A–ATARM–27-Jul-11
11032A–ATARM–27-Jul-11
(ADC_CHSR)
(ADC_SR)
(ADC_SR)
EOCx
DRDY
CHx
Conversion Results
Write the ADC_CR
with START = 1
When a conversion is completed, the resulting 10-bit digital value is stored in the Channel Data
Register (ADC_CDRx) of the current channel and in the ADC Last Converted Data Register
(ADC_LCDR). By setting the TAG option in the ADC_EMR, the ADC_LCDR presents the chan-
nel number associated to the last converted data in the CHNB field.
The channel EOC bit in the Status Register (ADC_SR) is set and the DRDY is set. In the case of
a connected DMA channel, DRDY rising triggers a data transfer request. In any case, either
EOC and DRDY can trigger an interrupt.
Reading one of the ADC_CDR registers clears the corresponding EOC bit. Reading ADC_LCDR
clears the DRDY bit and EOC bit corresponding to the last converted channel.
If the ADC_CDR is not read before further incoming data is converted, the corresponding Over-
run Error (OVREx) flag is set in the Overrun Status Register (ADC_OVER).
Likewise, new data converted when DRDY is high sets the GOVRE bit (General Overrun Error)
in ADC_SR.
The OVREx flag is automatically cleared when ADC_OVER is read, and GOVRE flag is auto-
matically cleared when ADC_SR is read.
Read the ADC_CDRx
Write the ADC_CR
with START = 1
Read the ADC_LCDR
SAM9G25
SAM9G25
923
923