FDC37C665IR SMSC Corporation, FDC37C665IR Datasheet - Page 129

• Manufacturer Part Number: FDC37C665IR
• Description: 3/5 Volt Advanced High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controller with Infranred Support
• Manufacturer: SMSC Corporation

CR5
This register can only be accessed when the
FDC is in the Configuration Mode and the
BIT NO.
4,3
0
1
2
5
6
7
1F0-1F7, 3F6,3F7
170-177, 376,377
ADDRESS
3F0-3F7
370-377
FDC Secondary
IDE Secondary
FDC DMA Mode
DenSel
swap drv 0,1
EXTx4
Reserved
Table 55 - CR5- Floppy Disk and IDE Extended Setup Register
BIT NAME
A low level on this bit selects the primary address for the FDC
interface (Default). A high level on this bit selects the secondary
address space.
A low level on this bit selects the primary address for the IDE
interface (Default). A high level on this bit selects the secondary
address space.
0=(default) Burst mode is enabled for the FDC FIFO execution
phase data transfers. 1=Non-Burst mode enabled. The FDRQ
and FIRQ pins are strobed once for each byte transferred while
the FIFO is enabled.
A high level on this bit, swaps drives and motor sel 0 and 1 of the
FDC. A low level on this bit does not (Default).
External 4 drive support: 0=Internal 4 drive decoder (default).
1=External 4 drive decoder (External 2 to 4 decoder required).
Set to 0 (default).
Bit 4
0
0
1
1
BLOCK NAME
Floppy Disk
Floppy Disk
Bit 3
0
1
0
1
IDE
IDE
129
Densel output
Normal (Default)
Reserved
1
0
CSR has been initialized to 05H. The default
value after power up is 00H.
DESCRIPTION
Primary address
Secondary address
Primary address
Secondary address
NOTES