lan9311 Standard Microsystems Corp., lan9311 Datasheet - Page 40
lan9311
Manufacturer Part Number
lan9311
Description
Lan9311/lan9311i Two Port 10/100 Managed Ethernet Switch With 16-bit Non-pci Cpu Interface
Manufacturer
Standard Microsystems Corp.
Datasheet
1.LAN9311.pdf
(460 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
lan9311-NU
Manufacturer:
CINCERA
Quantity:
3 023
Company:
Part Number:
lan9311-NU
Manufacturer:
Microchip Technology
Quantity:
10 000
Part Number:
lan9311-NU
Manufacturer:
SMSC
Quantity:
20 000
Company:
Part Number:
lan9311-NZW
Manufacturer:
Standard
Quantity:
2
Company:
Part Number:
lan9311-NZW
Manufacturer:
Microchip Technology
Quantity:
10 000
Company:
Part Number:
lan9311I-NZW
Manufacturer:
Standard
Quantity:
836
Company:
Part Number:
lan9311I-NZW
Manufacturer:
Microchip Technology
Quantity:
10 000
- Current page: 40 of 460
- Download datasheet (5Mb)
Revision 1.2 (04-08-08)
4.2.3.3
4.2.4
4.2.4.1
Note: When using the Reset bit to reset the Port 1 PHY, register bits designated as NASR are not
Refer to
Virtual PHY Reset
A Virtual PHY reset is performed by setting the VPHY_RST bit of the
(RESET_CTL), VPHY_RST bit in the
the
LAN9311/LAN9311i are affected by this reset.
Virtual PHY reset completion can be determined by polling the VPHY_RST bit in the
Register
or the Reset bit in the
normal conditions, the VPHY_RST and Reset bit will clear approximately 1uS after the Virtual PHY
reset occurrence.
Refer to
resets.
Configuration Straps
Configuration straps allow various features of the LAN9311/LAN9311i to be automatically configured
to user defined values. Configuration straps can be organized into two main categories: hard-straps
and soft-straps. Both hard-straps and soft-straps are latched upon Power-On Reset (POR) or pin reset
(nRST). The primary difference between these strap types is that soft-strap default values can be
overridden by the EEPROM Loader, while hard-straps cannot.
Configuration straps which have a corresponding external pin include internal resistors in order to
prevent the signal from floating when unconnected. If a particular configuration strap is connected to
a load, an external pull-up or pull-down resistor should be used to augment the internal resistor to
ensure that it reaches the required voltage level prior to latching. The internal resistor can also be
overridden by the addition of an external resistor.
Note: The system designer must guarantee that configuration strap pins meet the timing
Soft-Straps
Soft-strap values are latched on the release of POR or nRST and are overridden by values from the
EEPROM Loader (when an EEPROM is present). These straps are used as direct configuration values
or as defaults for CPU registers. Some, but not all, soft-straps have an associated pin. Those that do
not have an associated pin, have a tie off default value. All soft-strap values can be overridden by the
EEPROM Loader.
Straps which have an associated pin are also fully defined in
Configuration," on page
on the operation of the EEPROM Loader and the loading of strap values.
Upon setting the DIGITAL_RST bit in the
RELOAD command via the
original latched (non-overridden) values if an EEPROM is no longer attached or has been erased. The
associated pins are not re-sampled. (i.e. The value latched on the pin during the last POR or nRST
will be used, not the value on the pin during the digital reset or RELOAD command issuance). If it is
desired to re-latch the current configuration strap pin values, a POR or nRST must be issued.
Virtual PHY Basic Control Register
reset.
requirements specified in
If configuration strap pins are not at the correct voltage level prior to being latched, the
LAN9311/LAN9311i may capture incorrect strap values.
Section 7.2.10, "PHY Resets," on page 95
(RESET_CTL), the VPHY_RST bit in the
Section 7.3.2, "Virtual PHY Resets," on page 98
Table 4.2
Virtual PHY Basic Control Register (VPHY_BASIC_CTRL)
26. Refer to
provides a list of all soft-straps and their associated pin or default value.
EEPROM Command Register
Section 15.5.2, "Reset and Configuration Strap Timing," on page
DATASHEET
Section 10.2.4, "EEPROM Loader," on page 150
Power Management Control Register
40
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Reset Control Register (RESET_CTL)
(VPHY_BASIC_CTRL). No other modules of the
Power Management Control Register
for additional information on Port 1 PHY resets.
for additional information on Virtual PHY
(E2P_CMD), these straps return to their
Chapter 3, "Pin Description and
(PMT_CTRL), or Reset in
Reset Control Register
SMSC LAN9311/LAN9311i
until it clears. Under
or upon issuing a
for information
Reset Control
(PMT_CTRL),
Datasheet
447.
Related parts for lan9311
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Interface, Integrated USB2.0 Compatible 3-Port Hub
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Lan91c100fd Rev. B Feast Fast Ethernet Controller With Full Duplex Capability
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Feast ? Ast Ethernet Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Com20022i 10 Mbps Arcnet Ansi 878.1 Controller With 2k X 8 On-chip Ram
Manufacturer:
Standard Microsystems Corp.
Part Number:
Description:
Lpc47n207 Lpc Super I/o Irda Hot Docking Chip With Uart Data Brief
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Advanced I/o With X-bus Interface
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Fdc37m707 Enhanced Super I/o Controller With Wake-up Features
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Twenty Pin Uart Tpuart Corporation
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Enhanced Small Device Interface Controller
Manufacturer:
Standard Microsystems Corp.
Part Number:
Description:
Rpm-based Pwm Fan Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Rpm-based Pwm Fan Controller
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
Emc1001 1.5?c Smbus Temperature Sensor In Miniature Sot-23
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
1 Degree C Triple Temperature Sensor With Beta Compensation And Hotter Of Two Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
1 Degree C Multiple Temperature Sensor With Beta Compensation And Hottest Of Thermal Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet:
Part Number:
Description:
1 Degree C Triple Temperature Sensor With Resistance Error Correction & Hotter Of Two Zones
Manufacturer:
Standard Microsystems Corp.
Datasheet: