xr17v254 Exar Corporation, xr17v254 Datasheet - Page 54
![no-image](/images/manufacturer_photos/0/2/243/exar_corporation_sml.jpg)
xr17v254
Manufacturer Part Number
xr17v254
Description
66mhz Pci Bus Quad Uart With Power Management Support
Manufacturer
Exar Corporation
Datasheet
1.XR17V254.pdf
(70 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
xr17v254IV-F
Manufacturer:
Exar Corporation
Quantity:
10 000
Part Number:
xr17v254IV-F
Manufacturer:
EXAR/艾科嘉
Quantity:
20 000
XR17V254
66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
EFR[6]: Auto RTS or DTR Flow Control Enable
RTS#/DTR# output may be used for hardware flow control by setting EFR bit [6] to logic 1. When Auto RTS/
DTR is selected, an interrupt will be generated when the receive FIFO is filled to the programmed trigger level
and RTS/DTR# will de-assert (HIGH) at the next upper trigger or selected hysteresis level. RTS/DTR# will re-
assert (LOW) when FIFO data falls below the next lower trigger or selected hysteresis level (see FCTR bits 4-
7). The RTS# or DTR# output must be asserted (LOW) before the auto RTS/DTR can take effect. The selection
for RTS# or DTR# is through MCR bit [2]. RTS/DTR# pin will function as a general purpose output when
hardware flow control is disabled.
•
•
EFR[5]: Special Character Detect Enable
•
•
EFR[4]: Enhanced Function Bits Enable
Enhanced function control bit. This bit enables the enhanced functions in IER bits [7:5], ISR bits [5:4], FCR
bits [5:4], MCR bits [7:5,3:2] and MSR [7:2] bits to be modified. After modifying any enhanced bits, EFR bit [4]
can be set to a logic 0 to latch the new values. This feature prevents legacy software from altering or
overwriting the enhanced functions once set. Normally, it is recommended to leave it enabled, HIGH.
•
•
Logic 0 = Automatic RTS/DTR flow control is disabled (default).
Logic 1 = Enable Automatic RTS/DTR flow control.
Logic 0 = Special Character Detect Disabled (default).
Logic 1 = Special Character Detect Enabled. The UART compares each incoming receive character with
data in Xoff-2 register. If a match exists, the received data will be transferred to FIFO and ISR bit [4] will be
set to indicate detection of the special character. bit [0] corresponds with the LSB bit for the receive
character. If flow control is set for comparing Xon1, Xoff1 (EFR [1:0]=10) then flow control and special
character work normally. However, if flow control is set for comparing Xon2, Xoff2 (EFR[1:0]=01) then flow
control works normally, but Xoff2 will not go to the FIFO, and will generate an Xoff interrupt and a special
character interrupt.
Logic 0 = modification disable/latch enhanced features. IER bits [7:5], ISR bits [5:4], FCR bits [5:4], MCR
bits [7:5, 3:2] and MSR [7:2] bits are saved to retain the user settings. After a reset, all these bits are set to a
logic 0 to be compatible with ST16C550 mode (default).
Logic 1 = Enables the enhanced functions. When this bit is set to a logic 1 all enhanced features are
enabled.
54
REV. 1.0.0