ST72521 STMICROELECTRONICS [STMicroelectronics], ST72521 Datasheet - Page 162

• Manufacturer Part Number: ST72521
• Description: 8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC, FIVE TIMERS, SPI, SCI, I2C, CAN INTERFACE
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

ST72521
12 ELECTRICAL CHARACTERISTICS
12.1 PARAMETER CONDITIONS
Unless otherwise specified, all voltages are re-
ferred to V
12.1.1 Minimum and Maximum values
Unless otherwise specified the minimum and max-
imum values are guaranteed in the worst condi-
tions of ambient temperature, supply voltage and
frequencies by tests in production on 100% of the
devices with an ambient temperature at T
and T
range).
Data based on characterization results, design
simulation and/or technology characteristics are
indicated in the table footnotes and are not tested
in production. Based on characterization, the min-
imum and maximum values refer to sample tests
and represent the mean value plus or minus three
times the standard deviation (mean±3 ).
12.1.2 Typical values
Unless otherwise specified, typical data are based
on T
sign guidelines and are not tested.
Typical ADC accuracy values are determined by
characterization of a batch of samples from a
standard diffusion lot over the full temperature
range, where 95% of the devices have an error
less than or equal to the value indicated
(mean±2 )
12.1.3 Typical curves
Unless otherwise specified, all typical curves are
given only as design guidelines and are not tested.
12.1.4 Loading capacitor
The loading conditions used for pin parameter
measurement are shown in
Figure 82. Pin loading conditions
162/211
A
A
=25°C, V
=T
A
SS
max (given by the selected temperature
.
.
C
L
DD
=5V. They are given only as de-
Figure
ST7 PIN
82.
A
=25°C
12.1.5 Pin input voltage
The input voltage measurement on a pin of the de-
vice is described in
Figure 83. Pin input voltage
V
Figure
IN
83.
ST7 PIN