LAN9118_05 SMSC [SMSC Corporation], LAN9118_05 Datasheet - Page 121

• Manufacturer Part Number: LAN9118_05
• Description: High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
• Manufacturer: SMSC [SMSC Corporation]

High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
Chapter 7 Operational Characteristics
SMSC LAN9118
7.1
7.2
10BASE-T Operation
D0, 10BASE-T /w traffic
D0, Idle
D1, 10BASE-T /w traffic
D1, Idle
D2, Energy Detect Power Down
D2, General Power Down
100BASE-TX Operation
D0, 100BASE-TX /w traffic
D0, Idle
D1, 100BASE-T /w traffic
* Stresses exceeding those listed above could cause permanent damage to the device. This is a stress
Supply Voltage ................................................................................................................... +3.3V +/- 10%
Operating Temperature ..........................................................................................................0°C to 70°C
Storage Temperature.........................................................................................................-65°C to 150°C
Positive Voltage on any pin, with respect to Ground ........................................................................ 5.5V
Negative Voltage on any pin, with respect to Ground ..................................................................... -0.3V
Note: These maximum ratings do not apply to the following analog pins - ATEST, RBIAS, EXRES1,
rating only and functional operation of the device at any other condition above those indicated in the
operation sections of this specification is not implied.
Note: When powering this device from laboratory or system power supplies, it is important that the
Power measurements taken under the following conditions:
Temperature: .................................................................................................................................. +25° C
Device VDD:..................................................................................................................................+3.30 V
Absolute Maximum Ratings*
Power Consumption Device Only
TPO +/-, TPI +/-
absolute maximum ratings not be exceeded or device failure can result. Some power supplies
exhibit voltage spikes on their outputs when AC power is switched on or off. In addition, voltage
transients on the AC power line may appear on the DC output. If this possibility exists, it is
suggested that a clamp circuit be used.
Table 7.1 Power Consumption Device Only
MODE
DATASHEET
121
TOTAL POWER - TYPICAL (MW)
Revision 1.1 (05-17-05)
244
225
120
120
422
367
262
35
11