MC68HC912D60A MOTOROLA [Motorola, Inc], MC68HC912D60A Datasheet - Page 52

• Manufacturer Part Number: MC68HC912D60A
• Description: Microcontrollers
• Manufacturer: MOTOROLA [Motorola, Inc]

Pinout and Signal Descriptions
3.6 Port Signals
Technical Data
52
SDO/MOSI
1. In the 80-pin version PGUPD is connected internally to VDD
2. In the 80-pin version PHUPD is connected internally to VSS
Pin Name
SDI/MISO
KWG[6:0]
KWH[7:0]
AN1[7:0]
AN0[7:0]
IOC[7:0]
PGUPD
PHUPD
RxCAN
TxCAN
TEST
RxD1
RxD0
TxD1
TxD0
24 (KWH4
8 (KWG4
14–11,
80-pin
60–53
only)
only)
7–4
N/A
68
67
66
65
64
63
71
72
73
(1)
(2)
Pin Number
Table 3-2. MC68HC912D60A Signal Description Summary
84/82/80/78/
83/81/79/77/
9–11, 19–22
76/74/72/70
75/73/71/69
18–15, 7–4
112-pin
32–35,
The MC68HC912D60A incorporates eight ports which are used to
control and access the various device subsystems. When not used for
these purposes, port pins may be used for general-purpose I/O. In
addition to the pins described below, each port consists of a data register
49–52
104
105
94
93
92
91
90
89
97
13
41
Freescale Semiconductor, Inc.
For More Information On This Product,
Master out/slave in pin for serial peripheral interface
Master in/slave out pin for serial peripheral interface
SCI1 transmit pin
SCI1 receive pin
SCI0 transmit pin
SCI0 receive pin
Pins used for input capture and output compare in the timer and pulse
Analog inputs for the analog-to-digital conversion module 1
Analog inputs for the analog-to-digital conversion module 0
Used for factory test purposes. Do not connect in the application; may be
MSCAN transmit pin. Leave unconnected if MSCAN is not used.
MSCAN receive pin. Pin has internal pull-up; where msCAN module is not
Key wake-up and general purpose I/O; can cause an interrupt when an
Defines if I/O port resistive load is a pull-up or a pull-down, when enabled.
Key wake-up and general purpose I/O; can cause an interrupt when an
Defines if I/O port resistive load is a pull-up or a pull-down, when enabled.
accumulator subsystem.
bonded to 5.5 V max.
used, do not tie to VSS.
input transitions from high to low. On 80-pin QFP all 8 I/O should be
initialised.
input transitions from high to low. On 80-pin QFP all 8 I/O should be
initialised.
Pinout and Signal Descriptions
Go to: www.freescale.com
Description
MC68HC912D60A — Rev 3.0
MOTOROLA