HYB18H1G321AF QIMONDA [Qimonda AG], HYB18H1G321AF Datasheet - Page 20

• Manufacturer Part Number: HYB18H1G321AF
• Description: GDDR3 Graphics RAM 1-Gbit GDDR3 Graphics RAM
• Manufacturer: QIMONDA [Qimonda AG]

4.2
Rev. 0.92, 2007-10
06122007-MW7D-3G3M
A0-A11
RAS#
CAS#
CLK#
WE#
CKE
CLK
CS#
BA1
BA0
BA2
Extended Mode Register Set Command
Extended Mode Register Set Command (EMRS1)
COD
Mode
1
0
COD: Code to be loaded into
the register
Don't Care
FIGURE 8
20
The Extended Mode Register is used to control multiple
operation modes of the device. The most important one is the
organization as a 1-CS or a 2-CS device. Furthermore, it is
used to set the output driver impedance value, the termination
impedance value, the Write Recovery time value for Write
with Autoprecharge. It is used as well to enable/disable the
DLL, to issue the Vendor ID. There is no default value for the
Extended Mode Register. Therefore it must be written after
power up to operate the GDDR3 Graphics RAM.The
Extended Mode Register can be programmed by performing
a normal Mode Register Set operation and setting the BA0 bit
to HIGH. All other bits of the EMR register are reserved and
should be set to LOW.The Extended Mode Register must be
loaded when all banks are idle and no burst are in progress.
The controller must wait the specified time
initiating any subsequent operation
the EMRS command operation is equivalent to the timing of
the MRS command operation.
To apply an EMRS command, CS0 has to be used.
HYB18H1G321AF–10/11/14
(Figure
Internet Data Sheet
10). The timing of
1-Gbit GDDR3
t
MRD
before