AT90USB1286-16MU ATMEL [ATMEL Corporation], AT90USB1286-16MU Datasheet - Page 70

• Manufacturer Part Number: AT90USB1286-16MU
• Description: Microcontroller with 64/128K Bytes of ISP Flash and USB Controller
• Manufacturer: ATMEL [ATMEL Corporation]

70
AT90USB64/128
Table 9-1.
Notes:
Table 9-2
BOOTRST and IVSEL settings. If the program never enables an interrupt source, the Interrupt
Vectors are not used, and regular program code can be placed at these locations. This is also
the case if the Reset Vector is in the Application section while the Interrupt Vectors are in the
Boot section or vice versa.
Vector
No.
29
30
31
32
33
34
35
36
37
38
1. When the BOOTRST Fuse is programmed, the device will jump to the Boot Loader address at
2. When the IVSEL bit in MCUCR is set, Interrupt Vectors will be moved to the start of the Boot
Address
Program
Flash Section. The address of each Interrupt Vector will then be the address in this table
added to the start address of the Boot Flash Section.
shows reset and Interrupt Vectors placement for the various combinations of
reset, see
$003A
$003C
$003E
$004A
$0038
$0040
$0042
$0044
$0046
$0048
Reset and Interrupt Vectors (Continued)
(2)
“Memory Programming” on page
Source
ANALOG COMP
ADC
EE READY
TIMER3 CAPT
TIMER3 COMPA
TIMER3 COMPB
TIMER3 COMPC
TIMER3 OVF
TWI
SPM READY
Interrupt Definition
Analog Comparator
ADC Conversion Complete
EEPROM Ready
Timer/Counter3 Capture Event
Timer/Counter3 Compare Match A
Timer/Counter3 Compare Match B
Timer/Counter3 Compare Match C
Timer/Counter3 Overflow
2-wire Serial Interface
Store Program Memory Ready
368.
7593A–AVR–02/06