MC9S12E32CFU FREESCALE [Freescale Semiconductor, Inc], MC9S12E32CFU Datasheet - Page 107

• Manufacturer Part Number: MC9S12E32CFU
• Description: HCS12 Microcontrollers
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

2.4.1.3.1
The erase verify operation will verify that a Flash array is erased.
An example flow to execute the erase verify operation is shown in
write sequence is as follows:
After launching the erase verify command, the CCIF flag in the FSTAT register will set after the operation
has completed unless a new command write sequence has been buffered. Upon completion of the erase
verify operation, the BLANK flag in the FSTAT register will be set if all addresses in the Flash array are
verified to be erased. If any address in the Flash array is not erased, the erase verify operation will terminate
and the BLANK flag in the FSTAT register will remain clear.
Freescale Semiconductor
1. Write to a Flash array address to start the command write sequence for the erase verify command.
2. Write the erase verify command, 0x05, to the FCMD register.
3. Clear the CBEIF flag in the FSTAT register by writing a 1 to CBEIF to launch the erase verify
The address and data written will be ignored.
command.
Erase Verify Command
MC9S12E128 Data Sheet, Rev. 1.07
Figure
Chapter 2 128 Kbyte Flash Module (FTS128K1V1)
2-22. The erase verify command
107