M52S64322A-10BG ESMT [Elite Semiconductor Memory Technology Inc.], M52S64322A-10BG Datasheet - Page 13
![no-image](/images/no-image-200.jpg)
M52S64322A-10BG
Manufacturer Part Number
M52S64322A-10BG
Description
512K x 32 Bit x 4 Banks Mobile Synchronous DRAM
Manufacturer
ESMT [Elite Semiconductor Memory Technology Inc.]
Datasheet
1.M52S64322A-10BG.pdf
(47 pages)
DEVICE OPERATIONS (Continued)
AUTO PRECHARGE
The precharge operation can also be performed by using
auto precharge. The SDRAM internally generates the timing
to satisfy t
and CAS latency. The auto precharge command is issued at
the same time as burst write by asserting high on A10/AP,
the bank is precharge command is asserted. Once auto
precharge command is given, no new commands are
possible to that particular bank until the bank achieves idle
state.
ALL BANKS PRECHARGE
All banks can be precharged at the same time by using
Precharge all command. Asserting low on CS , RAS , and
(min) requirement, performs precharge on all banks. At the
end of t
state.
AUTO REFRESH
The storage cells of SDRAM need to be refreshed every
64ms to maintain data. An auto refresh cycle accomplishes
refresh of a single row of storage cells. The internal counter
increments automatically on every auto refresh cycle to
refresh all the rows. An auto refresh command is issued by
asserting low on CS , RAS and CAS with high on CKE
and WE . The auto refresh command can only be asserted
with all banks being in idle state and the device is not in
power down mode (CKE is high in the previous cycle). The
time required to complete the auto refresh operation is
specified by t
required can be calculated by driving t
time and them rounding up to the next higher integer. The
auto refresh command must be followed by NOP’s until the
auto refresh operation is completed. The auto refresh is the
preferred refresh mode when the SDRAM is being used for
normal data transactions. The auto refresh cycle can be
performed once in 15.6us.
Elite Semiconductor Memory Technology Inc.
WE with high on A10/AP after all banks have satisfied t
RP
RAS
after performing precharge all, all banks are in idle
RFC
(min) and “t
(min). The minimum number of clock cycles
RP
” for the programmed burst length
RFC
with clock cycle
RAS
SELF REFRESH
The self refresh is another refresh mode available in the
SDRAM. The self refresh is the preferred refresh mode
for data retention and low power operation of SDRAM.
In self refresh mode, the SDRAM disables the internal
clock and all the input buffers except CKE. The refresh
addressing and timing is internally generated to reduce
power consumption. The self refresh mode is entered
from all banks idle state by asserting low on CS ,
refresh mode is entered, only CKE state being low
matters, all the other inputs including clock are ignored
to remain in the refresh.
The self refresh is exited by restarting the external clock
and then asserting high on CKE. This must be followed
by NOP’s for a minimum time of t
reaches idle state to begin normal operation. 4K cycles
of burst auto refresh is required immediately before self
refresh entry and immediately after self refresh exit.
RAS , CAS and CKE with high on WE . Once the self
Publication Date: Aug. 2009
Revision: 1.3
M52S64322A
RFC
before the SDRAM
13/47