XC68HC05P18A Motorola, XC68HC05P18A Datasheet - Page 79

• Manufacturer Part Number: XC68HC05P18A
• Description: HCMOS Microcontroller Unit
• Manufacturer: Motorola

9.3.2 Serial Data Input (SDI)
9.3.3 Serial Data Output (SDO)
MC68HC05P18A
MOTOROLA
SDO
SCK
SDI
NOTE:
BIT 0
BIT 0
The master and slave modes of operation differ only by the sourcing of
SCK. In master mode, SCK is driven from an internal source within the
MCU. In slave mode, SCK is driven from a source external to the MCU.
The SCK frequency is mask option selectable. Available rates are OSC
divided by 2, 4, 8, or 16.
OSC divided by 2 is four times faster than the standard rate available on
the 68HC05P6.
Refer to
The SDI pin becomes an input as soon as the SIOP subsystem is
enabled. New data is presented to the SDI pin on the falling edge of
SCK. Valid data must be present at least 100 ns before the rising edge
of SCK and remain valid for 100 ns after the rising edge of SCK. See
Figure
The SDO pin becomes an output as soon as the SIOP subsystem is
enabled. Prior to enabling the SIOP, PB5 can be initialized to determine
the beginning state. While the SIOP is enabled, PB5 cannot be used as
a standard output since that pin is connected to the last stage of the
SIOP serial shift register. A mask option is included to allow the data to
100 ns
BIT 1
BIT 1
Figure 9-2. SIOP Timing Diagram
9-2.
1.4 Mask Options
Serial Input/Output Ports (SIOP)
BIT 2
BIT 2
BIT 3
BIT 3
for a description of available mask options.
BIT 4
BIT 4
BIT 5
BIT 5
100 ns
Serial Input/Output Ports (SIOP)
BIT 6
BIT 6
BIT 7
BIT 7
SIOP Signal Format
Technical Data
79