STEVAL-IFW001V1 STMicroelectronics, STEVAL-IFW001V1 Datasheet - Page 58

• Manufacturer Part Number: STEVAL-IFW001V1
• Description: BOARD EVAL BASED ON STR912FA
• Manufacturer: STMicroelectronics

Specifications of STEVAL-IFW001V1

• Design Resources: STEVAL-IFW001V1 Gerber Files STEVAL-IFW001V1 Schematic STEVAL-IFW001V1 Bill of Material
• Main Purpose: Interface, Ethernet
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: E-STE101P, STR912FAW44
• Primary Attributes: Dual Ethernet Transceivers for Full Duplex Communication
• Secondary Attributes: Up to 32 MII Addresses, UART, I2C, SPI, with RJ45 Connectors
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: ARM9
• Silicon Core Number: STR9
• Silicon Family Name: STR91x
• For Use With: 497-8263 - BOARD EXTENSION STEVAL-IFW001V1
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8262

Electrical characteristics
7
7.1
7.1.1
7.1.2
7.1.3
7.1.4
7.1.5
58/102
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
temperature range).
Data based on product characterisation, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
V
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Figure 10. Pin loading conditions
Pin input voltage
The input voltage measurement on a pin of the device is described in
DD
=1.8 V. They are given only as design guidelines and are not tested.
Doc ID 13495 Rev 6
C
L
=50pF
STR9 PIN
A
max (given by the selected
A
SS
= 25° C, V
.
.
DDQ
Figure
= 3.3 V and
Figure
STR91xFAxxx
11.
10.