Z8F083A0128ZCOG Zilog, Z8F083A0128ZCOG Datasheet - Page 83

• Manufacturer Part Number: Z8F083A0128ZCOG
• Description: KIT DEVELOPMENT F083A
• Manufacturer: Zilog
• Series: Z8 Encore! XP®r
• Type: MCUr

Specifications of Z8F083A0128ZCOG

• Contents: Hardware, Software and Documentation
• For Use With/related Products: Z8F083A
• For Use With: 269-4661 - KIT ACC ETHERNET SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4672

PS026308-1207
The steps for configuring a timer for PWM SINGLE OUTPUT mode and for initiating the
PWM operation are as follows:
1. Write to the timer control register to:
2. Write to the timer high and low byte registers to set the starting count value (typically
3. Write to the PWM high and low byte registers to set the PWM value.
4. Write to the timer reload high and low byte registers to set the reload value (PWM
5. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing
6. Configure the associated GPIO port pin for the timer output alternate function.
7. Write to the timer control register to enable the timer and initiate counting.
The PWM period is represented by the following equation:
If an initial starting value other than
registers, use the ONE-SHOT mode equation to determine the first PWM time-out period.
If TPOL bit is set to 0, the ratio of the PWM output high time to the total period is
represented by:
PWM Output High Time Ratio (%)
If TPOL bit is set to 1, the ratio of the PWM output high time to the total period is
represented by:
PWM Output High Time Ratio (%)
PWM Period (s)
–
–
–
–
0001H
PWM mode, counting always begins at the reset value of
period). The reload value must be greater than the PWM value.
to the relevant interrupt registers.
Disable the timer
Configure the timer for PWM mode
Set the prescale value
Set the initial logic level (high or low) and PWM high/low transition for the timer
output alternate function
). This only affects the first pass in PWM mode. After the first timer reset in
=
--------------------------------------------------------------------------- -
System Clock Frequency (Hz)
Reload Value
0001H
=
=
×
Reload Value PWM Value
----------------------------------------------------------------------- -
Prescale
--------------------------------- -
Reload Value
PWM Value
is loaded into the timer high and low byte
Reload Value
–
×
Z8 Encore!
100
0001H
Product Specification
.
®
×
F083A Series
100
Timers
71